User manual BELSON C23-WS

[. . . ] HOW TO GET PROFESSIONAL RESULTS WITH YOUR CURLING IRON This unique curling iron has been designed with multiple temperatures, providing very high heat in the HI (21-30) settings for curling very coarse, thick, hard-to-curl hair, and very low heat in the LO (1-6) settings for curling extra fine, damaged or dry hair. It also provides a full range of heat settings between LO and HI, for all normal textures and thicknesses of hair. FOR FAST HEAT-UP: With heat control dial set at desired position, allow unit to pre-heat. For optimum styling performance, let the iron continue to heat for about 2-3 minutes before using. [. . . ] LO (1-6): Use LO heat setting for very fine, fragile, light-colored hair. STYLING: Start by sectioning hair into strands of not more than 1 inch deep and 2 inches wide. Keep the hair strand smooth by brushing or combing through the section while holding the ends taut with the other hand. Taking one section at a time, place the ends of hair over the barrel with the clamp open. Then close the clamp, making sure that the ends extend just a tiny bit beyond the clamp. Grasp the safety tip with the other hand, and it will be easy to roll hair. Keep the section of hair taut as you wind it around the hot barrel by turning the handle with one hand and the safety tip with the other. Wind the curl toward the scalp as far as you wish to go without touching scalp with the hot barrel. Hold the curl in place for up to 20 seconds for tight curls or if hair is hard to curl. Hold for less time if hair is easy to curl, or if you want loose curls or just waves. When ready to release curl, unwind about half a turn (for longer hair, unwind a bit more) and push down on the clamp release lever to open the clamp. S Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged in any manner or dropped into water. Do not wrap the cord around the appliance. S Never use while drowsy or while sleeping. S Never drop or insert any object into any opening. S Do not use outdoors or operate where aerosol (spray) products are being used. Do not operate where oxygen is being administered. s This curling iron is hot when in use. To avoid burn hazard, do not let eyes and bare skin touch heated surfaces. S Do not place the heated unit directly on any surface while it is hot or still plugged in. S Do not use an extension cord with this appliance. This appliance has a polarized plug (one blade is wider than the other). [. . . ] Do not attempt to defeat this safety feature. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. Please return it to our Service Department or to an authorized service representative. [. . . ]