User manual BELSON DS-623DC W-DIFFUSER

[. . . ] To restore power, the reset button on the ALCI safety device must be pressed to reactivate the circuit. With speed switch in High (II) and heat switch in Low (I) position, fast speed and hot air. With both speed and heat switches in the High (II) position, fast styling speed and hottest air. When finger is released from the switch, the dryer will automatically resume the temperature and speed previously chosen. [. . . ] To avoid possible scalp or hair burns, use very hot setting only when hair is wet. Do not keep appliance directed at one place; keep it in constant motion. This is especially important if drying a wig, which could be damaged by heat. For maximum airflow, hold dryer no closer to the head than six inches. SPECIAL ATTENTION: This appliance is designed with a protective coating around the heating coils. When operating the first few times, there may be momentary smoking when unit is switched OFF. This represents no danger to the user and does not indicate a defect in the unit. This smoke should dissipate within a short time. To extend the life of the dryer, it is advisable to switch it to the low heat setting for a few seconds before shutting it off. HOW TO USE THIS DRYER This dryer features a choice of two speeds and four heat settings. Use high heats/speed for most styling/setting procedures and hair types. select lower heats/speed for "finishing" a hairstyle or for drying and styling permed , color-treated or fragile hair. To adjust heat and speed settings, operate switches as follows: With both speed and heat switches in the Low (I) position, slow speed and warm air. With speed switch in Low (I) and heat switch in High (II) position, slow speed and hot air. When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following: s READ ALL INSTRUCTIONS BEFORE USING. DANGER - As with most electrical appliances, electrical parts are electrically live even when the switch is off. To reduce the risk of death by electrical shock: s Always "unplug it" immediately after using. S Do not place or store appliance where it can fall or be pulled into tub or sink. S Do not place in or drop into water or other liquid. s If an appliance falls into water , "unplug it" immediately. [. . . ] Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. Please return it to our Service Department or to an authorized service representative. Never wrap the cord tightly around the appliance, as this could place undue stress on the cord where it enters the appliance and cause it to fray and break. [. . . ]