User manual BELSON MH5003

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] &\FOH &\FOH VH OH FWLRQ LQVWUXFWLRQV &\FOH GH VFULSWLRQ ' H WH UJH QW IRU SUH  ZDV K  ZDV K 5 LQV H $LG :DVK F\FOH GXUDWLRQ WROH UDQFH “  Very dirty dishes and pans (not to be used for delicate items) 6XSH U :DV K Cycle for normally dirty pans and dishes. Pre-wash with hot water at 40°C Extended wash at 65°C. 2 Rinses with cold water Rinse with hot water at 65°C . C old Rinse Rinse with hot water at 70°C .  ' DLO\ :DVK Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. 2 Cold pre-washes Extended wash at 50°C Hot rinse at 65°C Drying  J  5 DSLG ' U\ Economic and fast cycle to be used for slightly dirty Short wash at 47°C dishes. Run cycle Hot rinse at 65°C immediately after use.  J  6RDNLQJ Preliminary wash cycle for dishes while awaiting completion of the load with the dishes from the next meal. Short cold wash to prevent food from drying onto the dishes  ARISTON DISHWASHER - Instructions for installation and use 17 D ISHWASHER Water in your home Loading the salt. Always use salt which is intended for dishwasher use. The salt container is situated underneath the lower rack, fill it up as follows: 1. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. Use the special plastic elbow provided (see figure) to position it in the best possible way. The part of the pipe marked with the letter A should be between 40 and 100 cm above the ground. The pipe should not be immersed in water. Antinoise protection (where present) - On top of the dishwasher you will find two self-adhesive sponges. - Glue the small sponge onto the top cross-rod as shown in photograph 1. - Tilt the appliance and glue the large sponge as shown in photograph 2. Both sponges must be applied ensuring that they stick properly to the plate. [. . . ] C Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. [. . . ]