User manual BENQ DV2050

[. . . ] DV2050 20" LCD TV User's Manual Welcome Copyright Copyright BenQ Corporation. No part of this User's Manual may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ Corporation. Disclaimer BenQ Corporation makes no representations or warranties, either expressed or implied, with respect to the contents of this User's Manual. BenQ Corporation reserves the right to revise this publication and to make changes from time to time in the contents thereof without obligation to notify any person of such revision or changes. FCC Statement FCC Notice LCD TV DV2050: A CLASS B digital device This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] INPUT Press this button to select an input source. 10 Remote Control 15. "/!/$/#and ENTER button · "!: press the " or !· $#: press the $ or # buttons to adjust OSD menu settings. Press ENTER to execute selections, or to enter a submenu you have selected. FAVORITE Press this button to jump to the five favorite channels you have set. EXIT When operating the on-screen display, press this button to return to the next higher menu level. Press these buttons to raise or lower the volume. PENTER POWER INFO ASPECT PIP/PBP SLEEP FREEZE BACKLIGHT PIP AUDIO CH+/- PRESET 20. MUTE Press this button to mute the sound. Press it again to restore audio. MUTE VOL CH 21. MTS Press this button to select various audio systems (different TV systems have different selections). Channel select Press these buttons to select the channel you wish to view. RTN Press this button to toggle between two channels. MTS RTN Remote Control 11 Using the Remote Control When using the remote control, aim it at the remote control sensor window on the TV. If there is an object between the remote control and the signal remote control sensor window on the TV, the remote may not operate. When using the remote control, please note: · Do not strike or drop the remote. Do not expose the remote control to liquids and do not place it in humid environments. · Do not install or place the remote control in direct sunlight. · If the remote control sensor window on the TV is in direct sunlight or strong light, the remote control may not operate normally. In this situation, change the light source or readjust the angle of your TV, or operate the remote control from a location closer to the remote control sensor window on the TV. Batteries If the remote control does not operate, replace the batteries following the instructions below. 1. Open the lid of the remote control battery compartment (slide the lid backward while pressing down. ) 2. Insert two size-AAA batteries (included). Ensure that the batteries are inserted with the positive and negative terminals in the correct direction corresponding to the (+) and (-) marks in the battery compartment. 3. Press down on the lid of the battery compartment and gently push it back into position until it is firmly seated. 12 Remote Control Notes on Using Batteries The use of the wrong type of batteries may cause chemical leaks and/or explosion. Please note the following: · Always ensure that the batteries are inserted with the positive and negative terminals in the correct direction as shown in the battery compartment. [. . . ] · Check that the remote sensor window is not under strong fluorescent lighting. · Make sure the antenna cable is properly connected. · Consider whether TV signals are being properly received. Symptoms Remote control does not function properly There is no picture or sound, just noise 32 Troubleshooting Picture is not clear · Make sure the antenna cable is properly connected. [. . . ]