User manual BENQ DV3250

[. . . ] English DV3250 LCD Display User's Manual Welcome Copyright English Copyright BenQ Corporation. No part of this User's Manual may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ Corporation. TruSurround XT technology is incorporated under license from SRS Labs, Inc. Disclaimer BenQ Corporation makes no representations or warranties, either expressed or implied, with respect to the contents of this User's Manual. BenQ Corporation reserves the right to revise this publication and to make changes from time to time in the contents thereof without obligation to notify any person of such revision or changes. Important Safety Instructions Electrical energy can perform many useful functions, but it can also cause personal injury and property damage if improperly handled. [. . . ] If the set is already connected to a signal source, the display will display that signal. Turning off the display Press the button on the display again, or press the POWER button on your remote control again, and the display will go into standby mode. (The power indicator will turn red). Switching Inputs INPUT 1. Turn on all connected equipment or computers. Press the INPUT button on your display or press the INPUT button on your remote control to select input signal. Press the button repeatedly until your desired input is displayed. The sequence is as follows: TV -> AV1 ->AV1-S-> AV2 -> AV2-S->AV3->AV3-S->Component 1-> Component 2->PC->DVI->TV. . . AV1-S, AV2-S or AV3-S will appear only when the SVideo input of AV-1, AV-2 or AV-3 is connected. Using the Remote Control Adjusting Volume English Adjusting the volume 1. Press the VOL button on your display or press the VOL button on your remote to increase volume. The volume indicator will increase in length as volume rises. Press the VOL button on your display, or press the VOL button on your remote to decrease volume. The volume indicator will decrease in length as volume falls. Press the MUTE button on your remote control to temporarily cut off the sound. Press the MUTE button once more, or press the VOL or Power button on your display or the remote control to restore the sound level. MTS (TV Sound selection) Press the MTS button on your remote control to toggle among "Stereo", "SAP (Second Audio Program)", or "Mono" reception. MUTE MTS Changing Channels Using the Channel selection buttons on the Remote Control to Change Channels · To select a single- or double-digit channel, press the corresponding channel selection buttons on the remote control. For example, to select channel 8, press the "0" and "8" channel selection buttons on the remote control. · To select a triple-digit channel, press the button on the remote control followed by the rest of the digits. For example, to select channel 102, press the button, and then press the "0" and "2" buttons on the remote control. Using the CH channels / buttons to sequentially change Press the CH or CH button on the remote control, or press CH or CH on the display to sequentially select the TV channels available in your area. Using the channel button to return to the previous channel. To return to the previous viewed channel, press the Channel return button on your remote control. Using the Remote Control 17 Selecting a Picture Mode English Depending on the types (contents) of the TV program you are watching, you can select the most appropriate picture mode to make the image more vivid and lively. To change the picture mode, press the PRESET button on the remote control. This enables you to select from the 6 preset picture modes. You can also set up the picture mode you desire. [. . . ] · Check that the remote control sensor window is not under strong fluorescent lighting. There is no picture or sound, · Make sure the antenna cable is properly connected. · Change channels to confirm if the symptom is still present. Symptoms Troubleshooting 39 Picture is not clear. No sound. · Make sure the antenna cable is properly connected. [. . . ]