User manual BENQ DV3750

[. . . ] English DV3750 LCD Display User's Manual Welcome Copyright English Copyright BenQ Corporation. No part of this User's Manual may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ Corporation. Dolby, Pro Logic, and the double-D symbol are registered trademarks of Dolby Laboratories. Manufactured under license from Dolby Laboratories. [. . . ] Insert two size-AAA batteries (included). Ensure that the batteries are inserted with the positive and negative terminals in the correct direction corresponding to the (+) and (-) marks in the battery compartment. 3. Install the lid of the remote control battery compartment. Notes on Using Batteries The use of the wrong type of batteries may cause chemical leaks and/or explosion. Please note the following: · Always ensure that the batteries are inserted with the positive and negative terminals in the correct direction as shown in the battery compartment. · Different types of batteries have different characteristics. · Do not mix old and new batteries. Mixing old and new batteries will shorten battery life and/or cause chemical leaks from the old batteries. · When batteries fail to function, replace them immediately. · Chemicals which leak from batteries may cause skin irritation. If any chemical matter seeps out of the batteries, wipe it up immediately using a dry cloth. · Due to varying storage conditions, the battery life for the batteries included with your display may be shortened. If the remote control is not used for a long period of time, remove the batteries. Remote Control Using the Remote Control English Power on, Power off and Standby Turning on the display 1. After plugging the display's power cord into a wall outlet, the display will turn on and enter standby mode automatically. Press the Power button on the display, or press the (Power) button on the remote control. (The power indicator changes to green. ) Turning off the display Press the Power button on the display, or the (Power) button on the remote control again, and the display will go into standby mode. (The power indicator will turn red. ) Switching Inputs 1. Turn on all connected equipment or devices. Press the INPUT button on your display, or press the control to display the current selected input. Press the button repeatedly until your desired input is displayed. The sequence is as follows: TV -> AV1 -> AV1-RGB -> AV2 -> AV2-S->AV3->AV3-S->AV4->AV4-S->Component 1-> Component 2->PC->DVI->TV. . . AV3-S or AV4-S will appear only when the S-Video input of AV3 or AV4 is connected. Adjusting Volume Adjusting the volume 1. Press the Volume button on your display or press the + button on your remote control to increase volume. The volume indicator will increase in length as volume rises. [. . . ] · Check for any devices (PC or personal digital assistant, PDA) nearby that transmit infrared signal which may cause interference to signal transmission between the remote control and the LCD display. Turn off the infrared function of these devices. Troubleshooting 29 There is no picture or sound, just noise. Picture is not clear. No sound. · Make sure the antenna cable is properly connected. · Change channels to confirm if the symptom is still present. · Make sure the antenna cable is properly connected. [. . . ]