User manual BERNEX BN24201W CATALOGUE 2010

[. . . ] All technical specifications, drawings etc are subject to copyright law. 2011, BERNEX AG All rights reserved. User's manual BERNEX 42 Easy | 42 Plus | 42 Premium Table of contents 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1. 1 1. 2 1. 3 About this manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1. 1. 1 Conventions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 1. 1. 2 Symbols. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If you don't have to change direction for a long time, you will see only a straight arrow. The distance you must continue straight on is indicated underneath the arrow. If you tap on the large arrow box, the current route instruction will be repeated. At the same time the Driving Directions bar is phased in, allowing you to regulate the volume of the spoken driving instructions (see "Volume" on page 58). 7 If a traffic message along your route is reported, the Traffic Obstruction box will be shown at the top edge of the screen and the Traffic Information button (see point 8) will be phased in. Tap on (Close) to phase out the box. 8 The Traffic Information button is shown together with the Traffic Obstruction box (see point 7) when an obstruction is reported along your route. If a distance is indicated on the button, no detour route was calculated yet for the traffic obstruction in question. Tap on the Traffic Information button to open the TRAFFIC OBSTRUCTION window (see "Route Optimisation: On Request" on page 75). It shows a map view with the route section affected by the message and a possible detour. If no distance is indicated, all the obstructions which are reported for your route and would lead to a loss of time will be avoided. Tap on the Traffic Information button. A message appears telling you that the route has been optimised already. Tap on Details to open the TRAFFIC window (see "Displaying traffic information" on page 78). For details of the TMC function refer to chapter "TMC (Traffic Information)" on page 75. 9 - 56 - When you get close to your destination, the Parking button will appear. Working with the map User's manual BERNEX 42 Easy | 42 Plus | 42 Premium When you tap on the Parking button, the OPTIONS window opens and you have two options: You can select a car park from where you can then continue on foot. When you have parked your vehicle, you can save the current position and continue the navigation on foot. For a description of the Parking function refer to chapter "Parking near the destination" on page 68. 10 Ahead of many junctions the information from points 11 and 12 is hidden. Instead you are shown which lanes lead to your destination. Tap on the box in order to hide the lane information. 11 12 The height above sea level and the current speed are shown here. Instead you will receive a message when you are getting close to the destination. The map view follows your movements so that your position is always visible on the screen. If you leave the calculated route, the route will not be recalculated automatically. - 59 - Working with the map User's manual BERNEX 42 Easy | 42 Plus | 42 Premium If you are navigating on a route and more route points are still to follow, navigation to the next route point will be started immediately after the message. Traffic messages are not taken into account. Note: In pedestrian mode you must take care to hold the device without covering it at the top. The GPS receiver is located there and its reception could be impaired. 1 2 3 4 5 6 7 The direction in which your destination lies is indicated (red triangle). The part of the route which you have already covered is marked in green. The scale of the map section shown is indicated here. The length of the ruler corresponds to the distance indicated. The current position is indicated (orange arrow). You can see in which direction you are moving. The route which was calculated using the digitalised road system is marked in orange. [. . . ] 47 Scope of Delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Index - 113 - User's manual BERNEX 42 Easy | 42 Plus | 42 Premium Screenshots . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68 Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Settings Configuration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 101 TMC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]