User manual BEURER TL 100

[. . . ] Getting to know your device Dear customer, Thank you for choosing one of our products. Our name stands for high-quality, thoroughly tested products for applications in the areas of heat, weight, blood pressure, body temperature, pulse, gentle therapy, massage and air. With kind regards, Your Beurer team Why use a brightlight?When the hours of daylight are noticeably decreased in autumn and people increasingly stay inside, the effects of a lack of light may cumulate. [. . . ] Depending on the settings for your smartphone, additional charges may be incurred for connecting to the Internet or transferring data. Under the Bluetooth® menu item on your smartphone, select the brightlight TL 100. The blue Bluetooth®  LED on the brightlight will light up once the connection to the smartphone has been established. Select the “TL 100” device in the app settings. You can now use the app to control the brightlight and to adjust the moodlight (with brightness control and timer in each case). Beurer LightUp app features Daylight After downloading the “beurer LightUp” app and connecting the brightlight to a smartphone via Bluetooth® (see chapter “Initial use”), you can control the brightlight and the moodlight from the app. You can switch the daylight on and off using the app. In addition, you can also use the app to adjust the brightness and set a timer for the daylight. Moodlight You can use the app to adjust the moodlight. The app allows you to select from ten pre-configured moodlight settings (with brightness control and timer in each case). After activating a moodlight setting, a moodlight with change of colour begins to light up. The pre-configured moodlight settings can only be adjusted from the app. Note: The moodlight and “beurer LightUp” app must not be considered medical products. Adjustments to the daylight function must be made on the device itself!Operation 1 2 3 Insert the mains part into the connector. Switching on the lamp  Press the on/off button. LED display/timer The brightlight TL 100 indicates your current treatment time with the aid of 5 LEDs. The treatment time can be set at the following 5 levels. The timer function is not activated when the light is switched on for the first time. The light now shines until it is switched off again or a treatment time is set (timer = 0 min). In order to use the timer, set the desired level from 1 to 5 using the +/− buttons. On level 1, a treatment time of 15 minutes is set. [. . . ] The customer or the user should assure that it is used in such an environment. Immunity test Electrostatic discharge (ESD) IEC 61000-4-2 Electrical fast transient/burst IEC 61000-4-4 Surge IEC 61000-4-5 Voltage dips, short interruptions and voltage variations on power supply input lines IEC 61000-4-11 IEC 60601 test level ±6 kV contact ±8 kV air Compliance level ±6 kV contact ±8 kV air Electromagnetic environment – guidance Floors should be wood, concrete or ceramic tile. If floors are covered with synthetic material, the relative humidity should be at least 30% Mains power quality should be that of a typical commercial or hospital environment. Mains power quality should be that of a typical commercial or hospital environment. [. . . ]