User manual BEURER TL 30

[. . . ] € 2–7 G  right light B Instruction for Use. About the daylight lamp Dear valued customer, Thank you for choosing one of our products. Our name stands for high-quality, thoroughly tested products for applications in the areas of heat, weight, blood pressure, body temperature, pulse, gentle therapy, massage and air. With kind regards Your Beurer team Why use a daylight lamp? [. . . ] The position should be chosen to ensure a distance of between 20 cm and 40 cm between the user and the device. The lamp is most effective at this distance. Mounting the device on the wall Alternatively, you can also mount the device on the wall. This requires a solid wall with a stable suspension device (for concrete walls e. A 25 mm long M4 stainless steel self-tapping screw and wall plug). Only mount the device on the suspension device at the hole (located centrally on the rear of the device). Self-tapping screw and wall plug are not included in delivery. Important:  the area around the hole in the rear of the device is cracked or damaged, do not mount the device on the If wall!For help, please contact customer services or your retailer. Mains connection Connect the unit only to the mains voltage listed on the type plate. Push the plug completely into the mains socket. Note: • Ensure that there is a socket near the place where the lamp will stand. € Lay the mains cable in such a way that no one can trip over it. Operation 1 Switching on the lamp  Press the On/Off button. The tubes develop their full luminosity after a couple of minutes. 10 2 Enjoying the light Sit as close as possible to the lamp, between 20 cm and 40 cm. You can go about your normal activities while using it. You can read, write, make telephone calls, etc. €  very so often, briefly look directly into the light, since the effect results from the eyes/ retina receiE ving the light. €  se the brightlight as often as you want. However, the treatment is at its most effective if you carry U out the light therapy according to the prescribed time period of at least 7 successive days. €  he most effective time of day for the treatment is between 6am and 8pm T and we recommend that it is used for 2 hours per day. [. . . ] Mains power quality should be that of a typical commercial or hospital environment. Mains power quality should be that of a typical commercial or hospital environment. If the user of the “Mini Daylight” requires continued operation during power mains interruptions, it is recommended that the “Mini Daylight” be powered from an uninterruptible power supply or a battery. ±2 kV for power supply lines ±1 kV for input/output lines ±1 kV differential mode ±2 kV common mode ±2 kV for power supply lines ±1 kV for input/ output lines ±1 kV differential mode ±2 kV common mode <5 % UT (>95 % dip in UT) for 0, 5 cycle 40 % UT (60 % dip in UT) for 5 cycles 70 % UT (30 % dip in UT) for 25 cycles <5 % UT (>95 % dip in UT) for 5 sec 3 A/m Voltage dips, short interruptions and voltage variations on power supply input lines IEC 61000-4-11 <5 % UT (>95 % dip in UT) for 0, 5 cycle 40 % UT (60 % dip in UT) for 5 cycles 70 % UT (30 % dip in UT) for 25 cycles <5 % UT (>95 % dip in UT) for 5 sec Power frequency (50/60 Hz) magnetic field IEC 61000-4-8 3 A/m Power frequency magnetic fields should be at levels characteristic of a typical location in a typical commercial or hospital environment. [. . . ]