User manual BFT MOOVI 50

[. . . ] Read "Warnings" inside carefully!Make sure the spring is not under tension. Make sure the spring is not under tension and the boom is not fitted. Radiocomando già memorizzato Radio transmitter already memorised Radiocommande déjà mémorisée Bereits gespeicherte Funksteuerung Radiomando ya memorizado Reeds gememoriseerde afstandsbediening Radiocomando già memorizzato Radio transmitter already memorised Radiocommande déjà mémorisée Bereits gespeicherte Funksteuerung Radiomando ya memorizado Reeds gememoriseerde afstandsbediening Radiocomando da memorizzare Radio transmitter to memorise Radiocommande à mémoriser Zu speichernde Funksteuerung Radiomando que memorizar Te memoriseren afstandsbediening Radiocomando da memorizzare Radio transmitter to memorise Radiocommande à mémoriser Zu speichernde Funksteuerung Radiomando que memorizar Te memoriseren afstandsbediening Carefully read and comply with the Warnings booklet and Instruction booklet that come with the product as incorrect installation can cause injury to people and animals and damage to property. [. . . ] When the operator is out of order, activate the emergency release (see Fig. Y), if necessary, so as to release the manual boom opening and closing operations. SCRAPPING Materials must be disposed of in conformity with the current regulations. In case of scrapping, the automation devices do not entail any particular risks or danger. In case of recovered materials, these should be sorted out by type (electrical components, copper, aluminium, plastic etc. DISMANTLING WARNING: before opening the door, the spring must be unloaded (vertical boom). When the automation system is disassembled to be reassembled on another site, proceed as follows: - Disconnect the power supply and the entire electrical installation. - In the case where some of the components cannot be removed or are damaged, they must be replaced. Correct controller operation is only ensured when the data contained in the present manual are observed. The Company is not to be held responsible for any damage resulting from failure to observe the installation standards and the instructions contained in the present manual. The descriptions and illustrations contained in the present manual are not binding. The Company reserves the right to make any alterations deemed appropriate for the technical, manufacturing and commercial improvement of the product, while leaving the essential product features unchanged, at any time and without undertaking to update the present publication. 2) GENERAL INFORMATION Compact electromechanical barrier suitable for enclosing private areas and car parks and for use across entrances used by vehicle traffic only. available for entrance/exit points between 3 and 5 metres across. Adjustable electromechanical limit switches ensure the boom stops in the correct position. The emergency release for manual operation is operated by a lock with a personalized key. The actuator is always supplied ready for assembly on the left. Where necessary, the opening direction can always be reversed with a few simple operations. CBO (on request) can be supplied to make the barrier easier to install. Provision for accessories makes installing them straightforward, with no need to drill additional holes. During the closing operation, the balancing spring must never be fully compressed. 3 shows the position for determining the minimum size that the compressed spring can be allowed to reach with the boom in the open position (vertical). [. . . ] - Anything that is not explicitly provided for in these instructions is not allowed. - The operator's proper operation can only be guaranteed if the information given herein is complied with. The Firm shall not be answerable for damage caused by failure to comply with the installation rules and instructions featured herein. - Descriptions and illustrations herein are not binding. [. . . ]