User manual BH FITNESS SK2000

[. . . ] SK2000 STEPPER OWNER'S MANUAL BH FITNESS 20155 Ellipse, Foothill Ranch, CA 92610 Phone: 949-206-0330 Fax: 949-206-0013 Email: fitness@bhnorthamerica. com Web: www. bhnorthamerica. com and www. bhfitness. com SK2000 STEPPER Fig 1 A) B) C) D) E) F) G) H) I) J) K) L) - Monitor. - Main body - Hand rail Handlebar - Front trim cover. - The AC adapter - Screw M-10x 30 Quantity 2 - Screw M-10x 80 Quantity 2 - Allen screw M-6x65 Quantity 2 - Allen screw M-8x25 Quantity 2 - Allen screw M-8x55 Quantity 2 - Allen screw M-10x2 5 Quantity 1 - Screw Phillips M-5x15 Quantity 4 LL) - Screw Phillips M-4x15 Quantity2 M) - Flat washer M-10 Quantity 4 N) - Flat washer M-8 Quantity 2 O) - Grower washer M-8 Quantity 2 P) -Grower washer M-10 Quantity 5 Q) - Combination spanner R) - Star driver spanner S) -Allen key 5mm. V) -Allen key 8mm. 2 SK2000 STEPPER Fig 2 Fig3 3 SK2000 STEPPER Fig 4 Fig 5 4 SK2000 STEPPER Fig 6 Fig 8 Fig 7 5 SK2000 STEPPER IMPORTANT SAFETY INSTRUCTIONS User Safety 1. [. . . ] When pressed during exercise this key will decrease the exertion -Level level by one machine setting. During the selection of pre-programmed profiles, it is used to move on to the next profile screen. When pressed du ring exercise this key will increase the exertion -Level level by one machine setting. During the selection of pre-programmed profiles, it is used to move back to the previous profile screen. This is used during pre-programmed profile selection to select a profile, confirm data that have been entered and to start the exercise. It is also used during user profile programming to confirm the exertion level settings for each minute. -Pause Pause key. If this is pressed during a session, the exercise is interrupted and the exercise chronometer is halted. To restart the exercise chronometer press the Pause key again or continue exercising. There is a 45 second time limit in pause mode, after which the exercise will be taken as finished and the monitor will switch itself off. If, in pause mode, the STOP key is pressed then the exercise will be taken as finished. If this is pressed during the session, the exercise will be taken as finished and exertion settings will drop to minimum level. A summary of allthe exercise data will be displayed and it will then return to the start screen. Hold the STOP key down for 3 seconds in Start/Ready mode, and the console will automatically change to off status with a beep if the POWER option under project mode is on. -Quick / Start Quick start key. When this key is pressed, provided that the LED on the key is flashing, exercise will begin in manual mode. 15 SK2000 STEPPER STARTING In order to switch the monitor on it is necessary to pedal so that the crank spins, as soon as it reaches 45 r. p. m the monitor will come on and remain on for 60 seconds even after the pedal stopped so that you can program it. You can also plug the adapter that is supplied with the machine into an electrical outlet, assuming that you have chosen the ON option in the personalized settings (step 4 POWER). Once the monitor is on it will display the profile and the letter "M" for manual on the LED array ( A ) Figure 12, and the "WELCOME TO HI POWER" welcome message on the bottom alphanumeric screen ( B ). You can start the program in manual mode by pressing the QUICK / START key and by pressing the level or level keys you can increase or decrease the exertion levels. OPERATING INSTRUCTIONS STARTING THE FAN The monitor on this machine is fitted with an air vent (D), Fig. 11, through which a FAN provides two air speeds, LOW and HIGH. To switch the fan on while exercising press the ON / OFF key on the keypad, Fig. Whenever the monitor is switched to PAUSE the fan will switch off. SLEEP MODE This mode is activated if no RPM signal is received within 45 seconds when in stand-by mode. No windows are displayed while in this mode. You have to step on the footplate to produce a signal and reopen the display window. [. . . ] · A copy of the dated purchase receipt or credit card statement. · An explanation of the problem /malfunction or parts that are missing or damaged. · Owner's name, address and phone number. Forward your information to BH North America by FAX: (949) 206-0013 E-mail: fitness@bhnorthamerica. com Mail to: 20155 Ellipse, Foothill Ranch, California 92610, USA For troubleshooting assistance or to confirm your claim please phone: (949) 206-0330 BH FITNESS extends the following exclusive, limited warranty, which shall apply only to the use of the device in the home, or commercial facilities. [. . . ]