User manual BIAMP 29QPM QUALITY POWERED MIXERS

[. . . ] The information supplied by this manual relates to physical connections and assignment. For more details on software setup, please consult the Vocia Help File. Display Both the DS-4 and the DS-10 features a backlit display that provides the user with an easy-to-read interface to view paging information. Microphone The DS-4 and the DS-10 microphone has a cardioid polar pattern. [. . . ] All desk station units must have a unique Device ID to function within a Vocia Paging World (i. e. , it is not possible to have two desk station units with the same Device ID of hex 07). To assign a Device ID of hex 07, turn the LSB switch to 7 and leave the MSB switch on 0. To create an ID of hex B7, turn the LSB switch to 7 and turn the MSB switch to B. Device ID switches should be set using a 0. 1 inch (2. 5mm) to 0. 12 inch (3. 0mm) flat blade screwdriver. More information on setting IDs and the hexadecimal numbering scheme used in Vocia can be found in the Vocia Help File. Please note: Changes made to the Device ID while connected to the network require a power cycle in order to take effect. CobraNet Both the DS-4 and DS-10 are CobraNet devices. All CobraNet routing and bundle assignments are processed by the Vocia devices locally. Vocia devices are not interoperable with non-Vocia devices. Network Connection The DS-4 and DS-10 have two RJ45 connectors located on the bottom of the unit that are labeled (1) Audio Network and (2) Option. The Audio Network connector should be wired to shielded CAT5, CAT5e, CAT6 or CAT7 cable cabling to interface the DS-4 or DS-10 to a Vocia system via a PoE-compliant network switch. The Option connector is currently not used. it is turned OFF by default and must be set up in the Vocia software. DS-10: If PIN security is enabled via the Vocia software, the ten-digit keypad may be used to enter the required four-digit PIN. During PIN entry, the two "Next" and "Previous" soft key buttons on the right side of the display act as a "Clear" and an "Enter" key respectively. Input the four-digit PIN sequentially, followed by the "Enter" key or the PTT button. Each digit will be shown briefly on the display and subsequently replaced by an asterisk for security purposes. If the entered PIN is correct, the station will unlock and be ready for use. After a period of inactivity (no pages made and no buttons pressed), both the DS-4 and DS-10 will revert back to a locked state. This length of time (at a default of 180 seconds) is set using the Vocia software. To lock the station instantly, the user can press and hold down the "Next" and "Previous" buttons at the same time. 6 DS-4/DS-10 DiSplay Display Status Messages The following messages are used to display the state of the DS-4 or DS-10 during normal operation. more information on display status messages can be found in the Vocia Help File. [. . . ] Such evidence may consist of your sales receipt from an authorized BIAMP Systems dealer. Transportation and insurance charges to and from the BiAmP Systems factory for warranty service shall be your responsibility. This warranty will be VOID if the serial number has been removed or defaced; or if the product has been altered, subjected to damage, abuse or rental usage, repaired by any person not authorized by BIAMP Systems to make repairs; or installed in any manner that does not comply with BiAmP Systems' recommendations. Electro-mechanical fans, electrolytic capacitors, gooseneck microphones, cords connecting handheld microphones, hard-drives, displays, and normal wear and tear of items such as paint, knobs, handles, keypads and covers are not covered under this warranty. [. . . ]