User manual BIAMP DDP-281 DIGITAL DYNAMIC PROCESSOR OPERATOR

[. . . ] In most circumstances, this connection is not used, and power is instead provided at the Power + Data connection (see below). An external power supply may be necessary if CobraNet® network switches do not provide Power-Over-Ethernet (PoE) and PoE adapters are not available, or if it is desirable to perform certain Networked Paging Station-1 setup functions without an available CobraNet network connection (PoE). power + data: This RJ45 connector utilizes CAT5 cabling to interface the Networked Paging Station-1 to an AudiaFLEX system. This connection is made to the primary CobraNet port of an AudiaFLEX unit, either directly (single station) or via network switches (multiple stations). [. . . ] Use this setting in all cases, except when adding CobraNet® to an existing Ethernet network (not recommended). These settings may instead be assigned via software Device Maintenance. To set password protection, scroll to the Key icon and press Enter. Use the Scroll Wheel and Enter button to select the desired characters. Use the Cancel button to exit from a selection or screen. During normal operation, holding the Cancel button for 2 seconds will lock the unit, and the user will be prompted for the Lock Code before being given access. Lock Codes may instead be assigned via software Device Maintenance. To change the contrast of the LCD Panel, scroll to the Contrast icon and press Enter. Use the Scroll Wheel and Enter button to make adjustments. Use the Cancel button to exit from a selection or screen. Setup screen - ID Tag icon Edit Station ID screen Setup screen - Network icon Edit Net Config screen Setup screen - Key icon Edit Lock Code screen Setup screen - Contrast icon Edit LCD Contrast screen To change the behavior of the Push-To-Talk button, scroll to the Page Button icon and press Enter. Use the Scroll Wheel and Enter button to make a selection. To unlock the unit, use the Scroll Wheel and Enter button to enter the Lock Code. The unit will return to normal operation. During normal operation, a single page routing scheme (soft-button) is selected by simply scrolling over it before pressing Push-To-Talk. Multiple routing schemes may be selected, using the Scroll Wheel and Enter button. Multiple selections, indicated by check marks, are all applied when Push-To-Talk is pressed, and will be cleared when paging ends. The quantity of selected and available zones is indicated at the bottom of the LCD. When the Push-To-Talk button is pressed during normal operation, a Chime screen will appear briefly (if the selected scheme was programmed to include a chime). This is followed by a prompt for the user to begin talking. Also indicated are the quantity of selected and available paging zones, as well as the time remaining before Page Timeout (if a Timeout period has been specified). Setup screen - Mic icon Edit Mic Gain screen Setup screen - Button Order icon Edit Button Order screen Setup screen - Lock icon Enter Lock Code screen Single Button Page selection Multi-Button Page selection Initiating Chime Page In Progress 5 Networked Paging Station-1 - System Connections Networked Paging Station-1 units are connected to an AudiaFLEX system via Ethernet switches, forming a dedicated CobraNet® network. Multiple switches may be used to extend the CobraNet network. In systems designs that include multiple AudiaFLEX units, all Networked Paging Station-1 units and all AudiaFLEX units should be connected together on a common CobraNet network. In the system design, each Networked Paging Station-1 unit is associated by name with a Networked Paging Station block (Station ID). [. . . ] No agent, employee, distributor or dealer of Biamp Systems is authorized to modify this warranty or to make additional warranties on behalf of Biamp Systems. statements, representations or warranties made by any dealer do not constitute warranties by Biamp Systems. Biamp Systems shall not be responsible or liable for any statement, representation or warranty made by any dealer or other person. No action for breach of this warranty may be commenced more than one year after the expiration of this warranty. [. . . ]