Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BIAMP SPM412E CONTROLLER. We hope that this BIAMP SPM412E CONTROLLER user guide will be useful to you.
Lastmanuals help download the user guide BIAMP SPM412E CONTROLLER.
Manual abstract: user guide BIAMP SPM412E CONTROLLER
Detailed instructions for use are in the User's Guide.
[. . . ] The Controller may be wired up to 2000 feet from the SPM412e, using 2-conductor shielded cable (not included). The Controller overrides all similar commands which might be initiated from the front panel of the SPM412e (see NOTE below). [. . . ] There are no batteries to wear out, and it is not easily lost or stolen. The Controller may be wired up to 2000feet away from the SPM412e, using 2-conductor shielded cable (not included). Remove the mounting box from the front panel. Route the cable through a `knock-out' hole on the rear of the mounting box. Install the mounting box in a wall or panel, in the same orientation as any standard doublewide electrical box (do not rotate 90° as with other Advantage Wall-Mount panels).
Mounting Box
The mounting surface may be from 1/8" to 1" thick. (3. 175mm to 25. 4mm) The mounting cavity must be exactly 3. 6 inches high, 4 inches wide, and at least 2. 65 inches deep. (91. 44mm x 101. 6mm x 67. 31mm)
Insert the mounting box into the wall or panel, then tighten the flange screws until the flanges hold the box securely in place. Three screw terminals on the circuit board (`GND', `IR2', and `IR3') directly correspond to `Remote' terminals on the rear panel of the SPM412e. Connect the cable shield to the `GND' terminal at each end. Use the two conductors to connect `IR2' to `IR2' and `IR3' to `IR3'. A key-switch may be wired across the `KEY SWI' and adjacent `GND' terminals, allowing `user lock-out' of certain Controller functions. DIP switches are provided to defeat the front panel infrared detector, and to customize the key switch functions. The `IR' DIP switch completely disables infrared control. [. . . ] Product Model: Product Description: Applicable EC Directives: LVD Directive (2006/95/EC) EMC Directive (2004/108/EC) SPM412e and SPM412e Controller Stereo Program Mixer Applicable Harmonized Standards: Safety Emissions Immunity EN 60065:2002 EN 55103-1:1996, Environment E2 EN 55103-2:1996
Special Considerations for Product Environment or Compliance: Use only Biamp Systems supplied 24 VDC External Power Supply Adaptor. Shielded cabling must be used for system connections. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BIAMP SPM412E CONTROLLER
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BIAMP SPM412E CONTROLLER will begin.
