User manual BIAMP VOCIA WALL STATIONS

[. . . ] Vocia® WS-4/WS-10 EWS-4 Operation Manual Biamp Systems 9300 S. W. Gemini Drive, Beaverton, Oregon 97008 U. S. A. (503) 641-7287 www. biamp. com tablE Of cOntEntS VOcia Wall StatiOn 4/10 (WS-4/WS-10) fEaturES . Personal Identification Number (PIN) Security . [. . . ] The maximum distance between any unit and an Ethernet switch is 328 feet (100 meters) when using copper cabling. Additional Ethernet switches and/or fiber-optic cable can be used to further extend distances between units on a network. Please note that CobraNet limits network extensions to seven hops (one-way transmissions) within a network. Input the four-digit PIN sequentially, followed by the "Enter" key or the PTT button. Each digit will be shown briefly on the display and subsequently replaced by an asterisk for security purposes. If the entered PIN is correct, the station will unlock and be ready for use. After a period of inactivity (no pages made and no buttons pressed), both the DS-4 and DS-10 will revert back to a locked state. This length of time (at a default of 180 seconds) is set using the Vocia software. To lock the station instantly, the user can press and hold down the "Next" and "Previous" buttons at the same time. 7 S-4/WS-10 DiSplay Display Status Messages The following messages are used to display the state of the WS-4 or WS-10 during normal operation. more information on display status messages can be found in the Vocia Help File. Destination Idle: This status message indicates that the paging station is ready and there are no busy zones among the destinations selected by the Page Code. No Network: This status message indicates that the WS-4 or WS-10 is not connected to a functioning network. Please check network connections and settings. Destination Busy: This status message signifies that at least one of the destination zones is busy with a lower priority page. When paging into a busy zone, the lower priority message will be lost. Destination Delay: This status message indicates that at least one of the destination zones is busy with a page of equal priority. When paging into a busy zone at an equal priority, the message will be recorded in the WS-4 or WS-10 locally and played when the busy zones become available. Not Available: This status message indicates that the selected Page Code is not available. The message "Code Barred" or "Undefined" will appear in the top left corner of the display. Please choose a different Page Code or assign the selected Page Code to the wall station. Please Wait: This status message signifies that the PTT button has been pressed and the system is assigning paging resources and playing the chime. Simultaneously, the amber LED below the "Wait" icon will illuminate. [. . . ] Detach the white microphone connector from the board (and the Ethernet cable if connected). Use a pointed tool to release the catch located to the right of the microphone on the bottom side of the wall station. Slide the microphone cord to the left and remove the microphone cord. 5. Remove the metal catch from the original microphone. [. . . ]