User manual BIAMP WIN SOFTWARE V3.1

[. . . ] Ground (GND) See product manuals for remote control applications and wiring specifics. Soldered connections with heat-shrink, or properly sized crimp connectors, are recommended. See last page for back-box installation & block diagrams. RP-L1 RP-L2: The RP-L2 is a remote control panel, which consists of two 25k linear taper potentiometers mounted on a grey `decorator' style cover plate, with a single-gang `cut-in' style PVC electrical back-box and two pre-wired pigtails. [. . . ] The RP-L2 may be used to provide remote control of volume levels as specified for the following BIAMP products: products 801 Mic/Line Mixer . functions Main Output (level) Main Output (level) Main Output (level) Main Output (level) Inputs/Outputs (level) Various Products Audia (programmable) Nexia (programmable) . . The RP-L2 includes two pre-wired pigtails for ease of installation. Each pigtail consists of three 22-gauge wires, which are color-coded for wiring as follows: Red . Ground (GND) See product manuals for remote control applications and wiring specifics. Soldered connections with heat-shrink, or properly sized crimp connectors, are recommended. See last page for back-box installation & block diagrams. RP-L2 RP-S4 Remote Panel (Switches) RP-S4: The RP-S4 is a remote control panel, which consists of four doublepole*/double-throw switches mounted on a grey `decorator' style cover plate, with a single-gang `cut-in' style PVC electrical back-box and four pre-wired pigtails. For momentary switch operation, remove the jumper strap from each switch using needle-nose pliers. One end of the jumper is under the switch spring, which may need to be gently moved out of the way. If latching operation should again become necessary, replace the jumper straps by reversing this process. jumper strap Back-Box Installation Back-Box flange Remove the back-box from the front panel (controls). Route cables through a `knock-out' hole on the rear of the back-box. Install the back-box in a wall or panel, in the same orientation as any standard single-gang electrical box. The mounting surface may be from 1/8" to 1" thick. (3. 175mm to 25. 4mm) The mounting cavity must be exactly 3. 6" high, 2. 25" wide, and at least 2. 75" deep. [. . . ] (3. 175mm to 25. 4mm) The mounting cavity must be exactly 3. 6" high, 2. 25" wide, and at least 2. 75" deep. (91. 44mm H x 57. 15mm W x 69. 85mm D) Insert the back-box into the wall or panel, then tighten the flange screws until the flanges hold the box securely in place. Wire the remote panel pre-wired pigtails to the appropriate cable conductors. [. . . ]