User manual BIFINETT KH 511 MULTIMIXER

[. . . ] How to use the detachable shaft To prepare sauces, soups, puree, mayonnaise and baby food or to mix drinks and shakes. How to use the egg & cream mixer Insert the detachable shaft D in the motor block C and lock the shaft by turning it in clockwise direction. Before connecting the device with the mains, be sure that the local voltage corresponds to the voltage noted on the rating label. Never disconnect the plug from the socket by pulling the cord. [. . . ] After running the device for 1 minute, allow it to cool down for at least 5 Minutes. Only use the multimixer for mixing, blending, whisking, whipping and chopping foodstuffs and not for any other purpose. Keep these instructions in a safe place!Never switch on the multimixer before you have placed it in the mixing beaker or other mixing vessel. Push the detachable shaft D on the motor block C and lock the shaft by turning it in clockwise direction (see fig. Fix the egg & cram mixer attachment part I inserted in part J on the shaft simply by pushing it on until it engages (see fig. Do not open the lid of the container before the blade has stopped running. Be extremely careful when taking the blade out of the container, when emptying or cleaning. Fill the ingredients you wish to blend in the mixing beaker supplied H . However, before doing so, first remove the pot from the hotplate/gas. Hold the mixing beaker / pot to prevent it from slipping off the work surface due to the force of the running device. When the blending process has finished, unplug the multimixer from the power supply and allow it to cool down for 5 minutes. Pour the egg white/cream into the mixing beaker and turn the speed control A to the right to mix the egg white/cream with low speed. Plug in the multimixer; hold it upright in your mixing beaker, press the safety switch and keep it pressed until the egg white/cream has obtained the desired stiffness. Hold the mixing beaker firmly to prevent it from slipping off the work surface due to the force of the running device. Do not use the device for longer than one minute at a time at the lowest speed. Allow the appliance to cool down sufficiently before using it again. Once you have finished mixing, unplug and allow the appliance to cool down for 5 minutes. [. . . ] Now push the motor block C on the lid of the chopper and lock it by turning in clockwise direction (see fig. Plug in the multimixer, press it gently against the work surface and switch on the safety switch. This device is equipped with an electronic speed controller. When the speed control wheel is turned to the left the speed is increased, and reduced when turned to the right. [. . . ]