User manual BIONAIRE BAOF30G

[. . . ] · The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. · Holmes Products Europe undertakes within the specific period, to repair or replace free of charge, any part of the appliance found to be defective provided that: · We are promptly informed of the defect. · The appliance has not been altered in any way or subjected to misuse or repair by a person other than a person authorised by Holmes Products Europe. · No rights are given under this guarantee to a person acquiring the appliance second hand or for commercial or communal uses. · Any repaired or replaced appliance will be guaranteed on these terms for the remaining portion of the guarantee. [. . . ] · Do not place the fan or any parts near an open flame, cooking or other heating appliance. · Do not operate any appliance with a damaged mains cable, plug, after the appliance malfunctions, or has been dropped/ damaged in any manner. · The use of attachments not recommended or sold by the appliance manufacturer may cause hazards. · Do not let the mains cable hang over the edge of a table or counter, or come into contact with hot surfaces. · To disconnect from the electrical supply, grip the plug and pull from the wall outlet. · Always use on a dry, level surface. · Do not operate without the fan grills properly in place. · This product is intended for household use ONLY and not for commercial or industrial applications. · If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. · The appliance contains no user serviceable parts and should the product suffer damage or breakdown it must be returned to the manufacturer or its service agent. · Should the appliance stop working, first check the fuse in the plug (UK only) or fuse/circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. NOTE: Use caution when adjusting the tilt angle of the fan head to ensure that your fingers do not get caught. · If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid hazard. Please call 0800 052 3615 for assistance. Tools Required: Cross Head Screw Driver. Fit the Pole (A) and Rubber Ring (H) over the opening of the Glass Base (B) and secure with the Base Nut (C). Unscrew the Rear Grill Nut (D) from the Motor Housing (E). Position the Rear Grill (F) over the Motor Housing (E). Secure the Rear Grill (F) to the Motor Housing (E) with the Rear Grill Nut (D). Remove the protective sleeve from the Motor Shaft (G). Slide the Fan Blade (J) over the Motor Shaft (G) and tighten Blade Screw (L). [. . . ] The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN or GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. [. . . ]