User manual BIONAIRE BAP1550

[. . . ] BAP1550-IUK_07EM1. qxd 4/25/07 20:46 Page 1 · We are promptly informed of the defect. · The appliance has not been altered in any way or subjected to misuse or repair by a person other than a person authorised by Holmes Products (Europe) Ltd. · Faults that occur through normal wear and tear are not covered by this guarantee. · No rights are given under this guarantee to a person acquiring the appliance second hand or for commercial or communal uses. [. . . ] The filter clip should easily slide onto the filter hang tabs. Do not use force whilst attaching the filter clip to the filter. Align the clip on the permanent HEPA filter with the rails on the inside of the unit. (see Fig. 3) NOTE: The pleated material and rubber gasket should be facing towards the unit when applied. Replace the inlet grill by sliding back on to the unit. Make sure that it snaps securely into position (the grill only goes on one way). OPERATING INSTRUCTIONS Your remote control requires (2) AAA batteries (not included) for operation. To install the batteries, simply depress and slide the back of the remote control with your thumb on the arrow indentation. Insert batteries according to the diagram shown inside and replace cover. Remove batteries before discarding the remote control. · DO NOT mix old and new batteries. · DO NOT mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Press the power button ( ) on the control panel or the remote control. The unit will turn on high only the first time the unit is turned on. All other times it is turned on, the unit remembers the last speed selected and will turn on at that speed, and the power light will illuminate letting you know the power is on. You can then select the desired speed setting. This air cleaner has three speed settings. You can select from HIGH ( ), MEDIUM( ), or LOW ( ) by pushing the desired operating speed button on the control panel or the remote control. To release negative ions into the filtered air, press the ioniser button ( ) to either on the control panel or the remote control and the light will illuminate. The ioniser will not work unless the unit is running. For optimum air filtration, it is recommended to operate the air purifier continuously. Its rugged motor is designed to give many years of service. [. . . ] Replace the inlet grill by sliding back on to the unit. Make sure that it snaps securely into position (the grill only goes on one way). The filter life indicator ( ) must be reset once the permanent filters have been cleaned. Reset indicator by pressing the power button ( ) on the control panel for 2 seconds. [. . . ]