User manual BIONAIRE BAP2001

[. . . ] BAP2000/200105EM1 P. qxd 5/20/05 16:04 Page 1 PERMAtechTM ionizing air cleaner with MODEL BAP2000 BAP2001 Read instructions before operating. Retain for future reference. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any HMAN001. 05. US. OM1 9100040001773 BAP2000/200105EM1 questions or comments on your air cleaner, call 1-800-253-2764 in North America. BAP2000/200105EM1 P. qxd 5/20/05 16:04 Page 3 AIR CLEANER SAFETY PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: · Read all instructions before using the appliance. · To avoid fire or shock hazard, plug the air cleaner and Galileo® Wireless Air Quality Center directly into a 120V AC electrical outlet. · If the filter is covered by a bag when shipped: Remove plastic bag before use. [. . . ] Carefully remove your Galileo® Wireless Air Quality Center from the packaging materials. Select a firm level place on a tabletop or counter where there are no obstructions to the venting holes. Plug the air cleaner into a 120V AC electrical outlet. The air cleaner will begin to beep continuously until it is synchronized with the Galileo® Wireless Air Quality Center. Plug the Galileo® Wireless Air Quality Center into a 120V AC electrical outlet near the air cleaner. NOTE: The Galileo® Wireless Air Quality Center is designed to operate up to 30 feet from air cleaner. To set the alarm, press the "ALARM" SENSOR CONTRO L and "SET" buttons at the same time. The hour numbers will begin to flash and a small bell will appear in the bottom right hand corner of the LCD screen. Press "+" or "-" to set desired hour, then press "SET". When a button has not been pressed for a few seconds OR when the "SET" button is pressed again, the minute numbers will begin to flash. Press the "+" and "-" buttons to adjust the minutes as indicated above in step 2. When a button has not been pressed for a few seconds OR when the "SET" button is pushed again, the time will appear on the LCD screen and the alarm is set. A small bell will now appear in the bottom right hand corner indicating the alarm is operational. To check the alarm setting, press the "ALARM" button. Press the "TIME" button to return to clock mode. timer set clock alarm Figure 7 K J H G F L E I D A. Filter Service Indicator Light C B A Turning Alarm OFF 1. When the alarm goes off, a rapid beeping will be heard. To deactivate the alarm press the "ALARM" and "SET" button at the same time. The bell in the right hand corner will disappear. The longer the alarm sounds the louder it gets. Press the "ALARM" button only when the alarm is sounding and the alarm will turn off. After 10 minutes, the alarm will sound again. [. . . ] As the particle concentration in the air rises, so does the speed. In sensor control mode, the unit will always run at a minimum of SLEEP speed even if the particle levels are low to maintain ideal conditions. To turn the air cleaner onto "Sensor Control" mode, you must use the Galileo® Wireless Air Quality Center. Turn the air cleaner on using the Operating Instructions. [. . . ]