User manual BIONAIRE BASF1016

[. . . ] · The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. · Holmes Products Europe undertakes within the specific period, to repair or replace free of charge, any part of the appliance found to be defective provided that: · We are promptly informed of the defect · The appliance has not been altered in any way or subjected to misuse or repair by a person other than a person authorised by Holmes Products Europe. · No rights are given under this guarantee to a person acquiring the appliance second hand or for commercial or communal uses. · Any repaired or replaced appliance will be guaranteed on these terms for the remaining portion of the guarantee. [. . . ] Insert one pole through the base cover and twist pole clockwise to lock in position. Be careful to align the cutaway grooves on the threaded joint (male end) with the two protruding raised pieces inside the hollow end of the base cover. Now turn the base cover upside down (pole facing floor) and place the weighted insert into the base cover. The pole threads will be exposed as they protrude through the base insert. Hold the pole, base cover and weighted insert in one hand, place the base nut on the threaded section and hand tighten the base nut with the other hand. NOTE: Do not use a tool to tighten the base nut. Pole assembly You will need the second pole (O) (The poles are interchangeable). Insert the pole with the threaded joint (male end), into the hollow end of the second pole until both poles meet. Be careful to align the cutaway/grooves on the threaded joint (male end) with the two protruding pieces inside the hollow end of the second pole (female end) (P). Now slowly turn the pole with the threaded joint clockwise to lock it securely in place. Fan head assembly You are now ready to assemble the fan head. Position the rear grill (G) over the motor shaft (I) making certain that the 2 notches at the top and bottom of the rear grill, fit over the 2 prongs on the motor housing (J, M). Please make sure the rear grill sits securely against the motor housing. Secure the rear grill in its place using the rear grill mounting nut (F). Turn this nut clockwise and tighten firmly. Position the large fan blade (E), with the hollowed interior of the blade facing towards the rear grill, firmly onto the motor shaft. Align the motor shaft pin with the recessed groove on the back of the fan blade. Be sure that the shaft protrudes through the front of the blade. Position the small fan blade (D) into the hollowed interior of the large blade and press firmly into place. Also be sure that the shaft protrudes from the front of the blade. Secure the fan blades onto the motor shaft by turning the blade cap (C) anti-clockwise and tighten firmly. Centre the front grill (B) by aligning the Bionaire® logo on the logo plate (A) so that it is horizontal and parallel with the floor. Then, secure the front and rear grills completely together by pushing the front grill onto the clips, whilst holding the clips in place. Final assembly 1. [. . . ] Clean the fan blade, front and rear grills with a soft moist cloth. Replace the fan blade, tighten screw and securely fasten the front grill. Fan head, base and pole cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole and head. Please use caution around the motor housing area. [. . . ]