User manual BIONAIRE BASF1016G

[. . . ] ⷠTo disconnect from the electrical supply, grip the plug and pull from the wall outlet. ⷠDo not operate without the fan grills properly in place. ⷠThis product is intended for household use ONLY and not for commercial or industrial applications. ⷠShould the fan stop working, first check the fuse in the plug (UK only) or fuse/circuit breaker at the distribution board is operating, before contacting the manufacturer or service agent. [. . . ] Secure the rear grill in its place using the rear grill mounting nut (F). turn this nut clockwise and tighten firmly. Position the large fan blade (E), with the hollowed interior of the blade facing towards the rear grill, firmly onto the motor shaft. Align the motor shaft pin with the recessed groove on the back of the fan blade. Be sure that the shaft protrudes through the front of the blade. Position the small fan blade (D) into the hollowed interior of the large blade and press firmly into place. Also be sure that the shaft protrudes from the front of the blade. Secure the fan blades onto the motor shaft by turning the blade cap (C) anti-clockwise and tighten firmly. Centre the front grill (B) by aligning the Bionaire logo on the logo plate (A) so that it is horizontal and parallel with the floor. Then, secure the front and rear grills completely together by pushing the front grill onto the clips, whilst holding the clips in place. Insert the fan neck joint into the hollow end of the top pole and slowly turn the neck joint to lock in place. Be careful to align the cutaway/ grooves on the neck joint with the two protruding raised pieces inside the hollow end of the pole. Lastly, insert the tilt adjustment knob (N) into the neck joint and tighten until it is securely in place. To change the tilting angle of the fan head, simply loosen the tilt adjustment knob (N). Move the fan head to the desired angle, then firmly tighten the knob to lock in place. Height adjustment This fan is equipped with two poles which allow you to adjust the height of the fan for two height settings. With one pole only, the fan can be used on a table or floor. With both poles fitted it is a floor standing fan. Remove the fan head by turning it anti-clockwise 3 CLEANING AND MAINTENANCE Follow these instructions to correctly and safely care for your BionaireTM fan. please remember: · Always unplug the fan before cleaning or assembly. ⷠDo not allow water to drip on or into the fan motor housing. ⷠBe sure to use a soft cloth, moistened with a mild soap solution. [. . . ] GUARANTEE Please keep your receipt as this will be required for any claims under this guarantee. This appliance is guaranteed for 3 years after your purchase as described in this document. During this guaranteed period, if in the unlikely event the appliance no longer functions due to a design or manufacturing fault, please take it back to the place of purchase, with your till receipt and a copy of this guarantee. The rights and benefits under this guarantee are additional to your statutory rights, which are not affected by this guarantee. [. . . ]