User manual BIONAIRE BCM7203

[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using the appliance. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, near heat registers, radiator, stoves, or heaters. [. . . ] NOTE: In Manual Mode, only the LOW or HIGH power light will be lit. SmartTouchTM Humidistat Instructions: To take advantage of the SmartTouchTM Electronic Humidistat, press the MODE/OFF button until the speed is set in either the HIGH or LOW setting, and the desired Humidity is set. When the humidity level rises above the set humidity, the humidifier will stop. When the humidity level drops below the set humidity, the humidifier will turn on automatically. NOTE: When the SmartTouchTM Electronic Humidistat is set, either the HIGH or LOW power light and the percent humidity light will remain lit during operation. do not mix alkaline , standard (carbon-zine) , or rechargeable (nickel-cadmium) batteries. REPLACING THE FILTERS: Through normal use, waterborne minerals and sediment become trapped in the wick filters. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filters. You will be able to monitor the life of the filters in your humidifier by checking the FilterCheckTM Indicator. The FilterCheckTM Indicator will only read the filter condition when the humidifier is in operation. Figure 3 NOTE: It may take up to 60 minutes of operation for the FilterCheckTM Indicator to reflect the filter condition. New filters will register in the section reading Good filter. After frequent use of your humidifier, the FilterCheckTM Indicator will let you know when the filters need to be changed, see Figure 3. When the needle is in the (CHANGE) section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have Become trapped on your filters. At this point, you should replace your filters. Push the SmartTouchTM button (MODE/OFF) for 2 seconds to turn the unit OFF and disconnect from the electrical outlet. Do not remove rivet, replacement wicks come equipped with rivets for easy replacement. Insert new filters into each section of the wick holder making sure the rivet attaches to the wick holder securely. Do not use wicks without rivets as they will not produce the unit's intended output. Replace the wick holder into the base (it can only go in by following the arrow indicator) and replace main housing and then tank. It will take about 30 minutes for the humidifier to reach maximum output. You can purchase replacement filters (Model BWF100) by calling 1-800-253-2764 or by visiting www. [. . . ] In areas with hard water the filter will need to be changed more frequently. see Daily Maintenance under Cleaning and Maintenance instructions. Regular cleaning is recom mended to keep the unit functioning properly. To order Clean AwayTM (DMS216), call 1-800-253-2764, or visit www. [. . . ]