User manual BIONAIRE BCM7305RC

[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using the appliance. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs or near heat registers. [. . . ] humidity will increase in increments of 5%. When the humidity level is set, the display will return to show the current room humidity. When the room humidity level rises above the set humidity, the humidifier will stop. When the humidity level drops below the set humidity, the humidifier will turn on automatically. This means that when you turn the unit back on, it will be at the last setting the humidifier was set at. If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water reservoir, base and wick filter to prevent algae or bacteria growth. Select the Mode and or humidity you wish the humidifier to run in. While the humidifier is running, press and hold the up and down buttons simultaneously for 2 seconds. By pressing the up and down buttons, program the humidifier to turn off up to 16 hours later in increments of 1 hour. After setting the timer, the display will return to show the current room humidity. After the predetermined length of time has passed, the humidifier will automatically shut off. While the humidifier is off, press and hold the up and down buttons simultaneously for 2 seconds. By pressing the up and down buttons, program the humidifier to turn on up to 16 hours in advance in increments of 1 hour. After the preset length of time has passed, the humidifier will automatically turn on Auto Mode HI at 45% for a preset time of 2 hours. REPLACING THE FILTERS Through normal use, waterborne minerals and sediment become trapped in the wick filters. The harder your water, the greater the amount of minerals in the water, and the more often you will be able to monitor the life of your filters in your humidifier. You will be able to monitor the life of the filters in your humidifier by Figure 2 checking the Filter Monitor Indicator. After 60 minutes of use, Filter Monitor Indicator will move and indicate your filters condition. New filters will register in the section reading GOOD filter. After frequent use of your humidifier, the Filter Monitor Indicator will let you know when the filters need to be changed (see Figure 2). When the needle is in the CHANGE section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filters. At this point, you should replace your filters. [. . . ] The inside of the unit contains no user serviceable parts. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed warranty. Should your humidifier require service, please call 1-800-253-2764 in North America for further assistance. [. . . ]