User manual BIONAIRE BEF5000

[. . . ] 0 inches 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 mark for Drill mark for Drill Drilled Hole Bolt Wall Mounting Template Included for mounting: 4 - 1. 5" phillips head self tapping screws 4 - toggle bolts 2 - mounting brackets Fig. A Wall BRacKet GUIDe Toggle To mount into wall studs 1. Cut Mounting Template on dotted line and tape onto wall so brackets are centered on studs. Use level to make sure template is level. [. . . ] Only mode To Reset the Heater Remote does not work If your heater shuts down, follow these steps: 1. Change batteries (see Assembly Instructions) 1. Unplug the heater and wait 30 minutes 2. Be sure to point Remote at Control Panel on unit 2. Plug in the heater, turn the power ON 3. Be sure there are no obstructions between remote 3. Your heater should now be operating properly Heater) (Front of and unit 4. Make sure glass over LCD Display is clean TIP-OVER SHUT-OFF 5. Ideal range for Remote Control is within 20 feet If the heater is knocked over, it will instantly shut off. resume operation, simply place the heater in an upright 1. Increase thermostat setting to highest setting position and press the Power button. This is a 1500 watt heater and is intended for BULB REPLACEMENT supplement heat only (Back of Heater) Two 25W Candelabra Base Bulbs can be replaced by Heater cycles on and off frequently (Back of Heater) opening doors on back of unit with a flathead screwdriver. The thermostat automatically turns the heater on and off to maintain selected comfort level TROUBLESHOOTING 2. To make this occur less frequently adjust the · Please DO NOT attempt to open or repair (Back of Heater) thermostat setting up or down the heater other than bulb replacement. Please(Front of Heater) see the Warranty for Service Instructions or call our Consumer Services Department at 1-800-253-2764. Regulate flame brightness using the Flame (Front of Heater) button Brightness 2. Check both bulbs are working and replace if necessary (Front of Heater) LEA Y CONSERVE ESTAS IMPORTANTES PAUTAS DE SEGURIDAD INSTRUCCIONES IMPORTANTES: Al usar aparatos eléctricos, se deben siempre seguir precauciones básicas de seguridad para reducir el riesgo de incendio, choque eléctrico y lesiones a las personas, incluidas las siguientes precauciones: 1. Lea todas las instrucciones antes de usar el aparato. Para evitar incendios o peligro de choque eléctrico, conecte el aparato directamente en un tomacorriente eléctrico de 120V AC. El calentador se calienta cuando está en uso. Para evitar quemaduras, NO permita que la piel toque las superficies calientes. Use la manija cuando mueva el calentador. [. . . ] Cerciórese de que el vidrio de la pantalla LCD esté limpio. La distancia ideal para el control remoto es de 20 pies. Aumente el grado de calor del termostato al grado más alto. Este es un calentador de 1500 vatios y su función es para suministrar solamente calor. [. . . ]