User manual BIONAIRE BFH261

[. . . ] Check on the following website for further recycling and WEEE information: www. bionaire. com or e-mail info-europe@jardencs. com FAN heater BFH261 BFH265 Holmes Products (Europe) Ltd 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: info-europe@jardencs. com Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 © 2007 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All Rights Reserved. 9100020007773 BFH261/265IUK07EM1 INSTRUCTION MANUAL BFH261/265IUK07EM1. qxd 6/8/07 9:28 AM Page 5 BFH261/265 Fig. 1 U. K. and IRELAND Fig. 2 GENERAL DESCRIPTION (FIG. [. . . ] Oscillation Instructions (BFH265 only) Press button (G) to start and button (G) again to stop oscillation. AUTO SAFETY SHUT-OFF This heater is equipped with a technologically advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. Press the MODE/OFF button for two seconds or keep pressing the button until all the temperature indicator lights are OFF. Unplug the heater and wait for 30 minutes for the unit to cool down. After the 30 minutes, plug the unit in again and operate normally. Safety Back-Up Fuse In the unlikely case the heater does not respond to an overheat situation, the safety back-up fuse will engage. In this case, the heater will not reset. Please contact your local service number on the back of the manual for advice. PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: 1. Before connecting the heater, check that the voltage indicated on the rating plate corresponds to the main voltage in your home/office. WARNING: In order to avoid overheating, do not cover the heater . DO NOT position the heater directly under a power socket. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. A D C E PRESS 1 2 F TEMPERATURE II I II HIGH (2 kW) LOW (1 kW) HIGH (2 kW) 16°C, 18°C, 20°C, 22°C, 24°C LOW (1 kW) 16°C, 18°C, 20°C, 22°C, 24°C O/Off 3-7 G (BFH265) 8 - 12 13 I O/Off ADDITIONAL FEATURES: 1. Press & hold at any time to turn the heater off. Heater will save the last setting in memory. Press to turn heater on and heater will recall the last setting in memory. 5. If the supply cord or plug is damaged, it must be replaced by the manufacturer or its service agent or similarly qualified person in order to avoid hazard. The heater contains no user serviceable parts. Should the product suffer damage or breakdown, it must be returned to the manufacturer or their service agent. Under the environment with electrical fast transient, the product may malfunction and require user to reset the product. [. . . ] INSTALLATION OF A PLUG Applicable to U. K. and Ireland The wires in the mains lead are coloured as such: BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. [. . . ]