User manual BIONAIRE BFH3520

[. . . ] OSCILLATION INSTRUCTIONS Press ( ) button J to start and ( ) button J again to stop oscillation. REMOTE CONTROL INSTRUCTIONS Before operation, insert 2 "AAA" batteries (not included) into the back of the remote control. Remove batteries before discarding the remote control. · Do not mix old and new batteries. [. . . ] DO NOT use the heater in rooms with explosive gas (e. g. petrol) or while using inflammable glue or solvent (e. g. when gluing or varnishing parquet floors, PVC etc. ) 14. DO NOT insert any objects into the heater. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater is to be installed so that switches and other controls cannot be touched by a person in the bath. Avoid the use of an extension cord because it may cause the heater to overheat. and Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please refer to "Installation of a plug" below. Installation of a plug Applicable to U. K. and Ireland The wires in the mains lead are coloured as such: BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E", or with the earth symbol or coloured GREEN and YELLOW. NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician. If a 13A 3-pin plug is 13 amp fitted, it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 13A fuses must be BSI or ASTA BS1362 approved. GUARANTEE PLEASE KEEP YOUR RECEIPT AS THIS WILL BE REQUIRED FOR ANY CLAIMS UNDER THIS GUARANTEE. · This product is guaranteed for 2 years. · In the unlikely event of breakdown, please take it back to the place of purchase, with your till receipt and a copy of this guarantee. · The rights and benefits under this guarantee are additional to your statutory rights which are not affected by this guarantee. [. . . ] This cool down process ensures an accurate and consistent temperature reading. Press the Mode Button one more time to turn the heater to (AF) mode and one final time to turn the heater off. When the heater is off, the room temperature will only be displayed. NOTE: The Mode Button can be pressed and held for 3 seconds at any time to turn the heater off. [. . . ]