User manual BIONAIRE BFH6616

[. . . ] Holmes undertakes within the guarantee period to repair or replace the appliance, or any part of appliance found to be not working properly free of charge provided that: · you promptly notify the place of purchase or Holmes of the problem; and · the appliance has not been altered in any way or subjected to damage, misuse, abuse, repair or alteration by a person other than a person authorised by Holmes. Faults that occur through, improper use, damage, abuse, use with incorrect voltage, acts of nature, events beyond the control of Holmes, repair or alteration by a person other than a person authorised by Holmes or failure to follow instructions for use are not covered by this guarantee. Additionally, normal wear and tear, including, but not limited to, minor discoloration and scratches are not covered by this guarantee. The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. [. . . ] if the heater was accidentally covered) the system will automatically switch the heater off. Operation can only be resumed if the user resets the heater as detailed below. Unplug the heater and allow 30 minutes for the heater to cool down. After 30 minutes plug the heater in and operate normally. If the heater does not work normally, repeat steps 1 and 2 again. TIP-OVER SHUT-OFF When the unit is accidentally knocked over, it will instantly shut off. To reset, simply place the heater in an upright position and press the Mode ( ) button it will operate normally. CLEANING/MAINTENANCE During Season Care: 1. Always unplug the heater before cleaning. Clean the unit with a soft cloth moistened with a mild soap solution. NEVER use abrasive or flammable solvents to clean the unit. After cleaning, be sure to completely dry the unit with a cloth or towel. STORAGE TIPS If the heater is not required for long periods, for example during the summer, it should be stored in a dry place and preferably covered to prevent the accumulation of dust and dirt. TROUBLESHOOTING If your heater fails to operate: · First check the fuse in the plug (UK only) or fuse / circuit breaker at the distribution board is operating. · Check for obstructions which could prevent airflow and cause overheating. If you find an obstruction turn the heater OFF, carefully remove the obstruction and follow the Reset instructions above. · The Thermostat might be set too low. Raise the Thermostat until the heater restarts. PLEASE READ AND SAVE THESE IMPORTANT INSTRUCTIONS When using electrical appliances, basic safety precautions should always be taken including the following: 1. Before connecting the heater, check that the voltage indicated on the rating plate corresponds to the main voltage in your home/office. WARNING: In order to avoid overheating, do not cover the heater ( ). DO NOT position the heater directly under a power socket. DO NOT use this heater in the immediate surroundings of a bath, a shower or a swimming pool. [. . . ] NOTE: When the thermostat is set, either the 2 or 1 power light indicator, and the set temperature light will remain lit during operation. (See Figure 2) NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. When the preset temperature is made, the fan will run for 30 seconds without heat. [. . . ]