User manual BIONAIRE BOH15001

[. . . ] for further recycling and WEEE information. 4 · The BROWN coloured wire must be connected to the pin terminal, which is marked with the letter L (Live) or is coloured RED. · The BLUE coloured wire must be connected to the pin terminal which is marked with the letter N (Neutral) or is coloured BLACK. · DO NOT CONNECT either of these wires to the earth terminal in the plug. [. . . ] The heater is to be placed at least 3m from water source. DO NOT use this heater when it is lying on its side. DO NOT use the heater in rooms with explosive gas (e. g. petrol) or while using, oxygen, inflammable glue or solvent (e. g. when gluing or varnishing parquet floors, PVC etc. ) 14. DO NOT insert any objects into the heater. Keep the mains cord at a safe distance from the main body of the heater. If overheating should occur, the built-in overheating safety device will switch off the heater. The heater cannot be used adjacent to curtains or combustible material. Curtains or combustible material may be burned if the heater was installed incorrectly. 19. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. U-bolt Technical Specifications BOH1501 Wattage: 1500W BOH2001 Wattage: 2000W 4. Place the front stand (G) on the bottom of the radiators front panel, and secure it with the Q shape screw (K). This front stand (G) is not meant to be removed once it is attached to the bottom of the unit. After installation of the front stand (G) and foot plate (M) with casters (L) turn the heater the right way up: the heater is now ready for use. Set the unit to the OFF (O) position. NOTE: Unit must be unplugged for it to be fully off TIP OVER PROTECTION When the unit is accidentally knocked over, or tilts on one side at more than a 45° angle; it will instantly shut off. To reset, simply place the heater in an upright position. H I D J 2. The Power Light (I) will illuminate and remain lit until the heater is unplugged. STORAGE TIPS If the heater is not required for long periods, for example during the summer, it should be stored at room temperature; in a dry place and preferably covered to prevent the accumulation of dust and dirt. 3. Set the Thermostat Knob (J) all the way to the right. NOTE: When the heater is in use, it is normal that the heater cycles ON and OFF, this is to maintain your desired temperature. 4. Turn the Control Knob (H) to desired level of heat. After using the heater, turn the Control Knob (H) to "0" position, turn the Thermostat Knob (J) to lowest temperature position and unplug the heater from the socket. Turn the Control Knob to desired heat setting. [. . . ] Please make sure you have all of the following acessories prior to throwing away packaging. 1 Foot Plate with 2 casters (M&L), 1 Front Stand (G), and 1 Q shape Screw (K) and 1 Wing Nut (N). ASSEMBLY INSTRUCTIONS (See Fig. 3) Please make sure the heater has not been plugged into any electricity outlet. NOTE: The Power light will remain lit during operation. 1. Turn the heater upside down and you will see one U-bolt (O) with wing nut over the last joint of the heater. [. . . ]