User manual BIONAIRE BPH1009

[. . . ] BPH1009IUK06EM1. qxd 8/15/06 3:05 PM Page 1 600W Panel Heater with GalileoTM technology BPH1009 Fig. 1 Galileo remote Control Panel Holmes Products (Europe) Ltd 1 Francis Grove London SW19 4DT England Fax: +44 (0)20 8947 8272 Email: info-europe@jardencs. com Website address: www. bionaire. com UK - Free phone Customer Service Helpline ­ 0800 052 3615 C D E B A MODEL: BPH1009, BPH1009 (Tx) 220-240V~50Hz 500-600W OPERATING FREQUENCY: 433. 9MHz VOLTAGE SUPPLY: Tx: DC4. 5V © 2006 JCS/THG, LLC Bionaire®, the Bionaire logoTM and GalileoTM are trademarks of JCS/THG, LLC. F INSTRUCTION MANUAL 9100020007404 BPH1009IUK06EM1 A. Foot Base (2) BPH1009IUK06EM1. qxd 8/15/06 3:05 PM Page 4 ENGLISH Fig. Your Bionaire® Heater has been designed using the latest in technology. [. . . ] USE OF GALILEOTM REMOTE CONTROL · The display can show either Fahrenheit or Celsius. To change the reading on the remote control display, unlock the remote, then turn the remote over and push the button located on the right hand side, under the stand, with a ball point pen tip. This switch will change the reading from ºF to ºC and vice versa. · Whilst using the remote, the backlight function will automatically turn on when any button is pushed and will turn off after 15 seconds of non-use. · The maximum transmission distance for the remote control is 30 ft. Do not use or position the remote more than 30 ft (9 Metres) from heater. For accurate temperature control the remote control must be used in same room as heater. · When positioning the remote control, use the flip up stand on the reverse side. · Always position the remote control at least 3 ft. (1 Metre) from the heater in a convenient position away from draughts or anything that would influence the room temperature reading. For example, cold window-sill or under warm lighting. · Because heat rises and the remote control senses temperature, the remote control should not be positioned higher than 4 ft (1. 2 Metres) from the floor. · NEVER place the remote control on the storage hook on the heater when it is in use. This will upset the readings and prevent proper and satisfactory operation. 5) · The "Room" temperature will always display on the remote screen if good batteries are in the remote. · If the batteries are running low on power, a low battery indicator will appear on the remote. Low batteries will effect transmission distance and the screen contrast. We recommend replacing batteries immediately. Do not mix old and new batteries. · · Every minute while in "AUTO" mode, the remote control communicates with the heater. If the remote control goes out of range and/or has low batteries, the communication will stop, and after 8 minutes of noncommunication, the heater will shut off. · Do not cover the remote control whilst in use as this may affect the accuracy of the temperature reading. HEATER OPERATION WITH REMOTE When the heater is plugged into the mains supply, the power light (Red) will illuminate to signal that the unit is in stand-by mode. [. . . ] DO NOT use soap or chemicals, which may damage the housing. Allow sufficient time to dry before plugging the unit back in the socket. · Clean the air inlet and outlet openings regularly (with normal use at least twice a year) with a vacuum cleaner. STORAGE TIPS If you do not plan to use your heater for an extended period of time (i. e. during the summer months), we recommend you to re-pack the unit in its original packaging or any other dust-free packaging and store it in a dry and cool place. [. . . ]