User manual BIONAIRE BPH1520-I

[. . . ] Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. DO NOT position where it can be touched by children, especially the very young. Allow a safe area around the heater away from furniture or other objects; at least 50 cm from the top and sides and 200 cm at the front. Do not use this heater when it is lying on its side. [. . . ] Hang the main body on the Mounting Bracket. With the heater off, press and hold (+) and (-) simultaneously until the display flashes and display the number “0”. Press (+) or (-) to select the amount of time you would like to pass before the heater turns on. After setting the timer, the display shows a red dot next to the current room temperature on the display to indicate that the timer is activated. After the programmed length of time has passed, the heater automatically turns on Auto HI at 24°C (75°F) for 2 hours. With the heater running, press and hold (+) and (-) simultaneously until the display flashes. Press (+) or (-) to select the amount of time you would like the heater to run. After setting the timer, the display shows a RED dot next to current room temperature on the display to indicate that the timer is activated. The heater automatically shuts off after the programmed length of time has passed. PROGRAMMABLE TIMER (BPH1520 Only) You can program your heater to turn on at a preset time or turn off after a set amount of time. The heater will now automatically retain the temperature at the required level. To turn the unit off rotate the mode adjustment knob anti-clockwise to the (0) position. FROST GUARD (BPH1414) Keep unit in 1 (low setting) or 2 (high setting) rotate thermostat adjustment knob to beginning position ( ). In this mode, the heater is off until the room’s temperature reaches freezing and the heater automatically turns on HI power. The heater will cycle ON and OFF as it maintains the temperature between 5-8 °C. FROST GUARD (BPH1520) Press the( ) Mode button 5 consecutive times for Anti Frost setting (AF will show in the digital display). This special setting is automatically activated when the (AF) mode is selected. In this mode, the heater is off until the room’s temperature reaches freezing and the heater automatically turns on HI power. The heater will cycle ON and OFF as it maintains the temperature between 5-8 °C. AUTO SAFETY SHUT OFF The heater has a built in safety device which will switch off the heater automatically in case of accidental overheating. It can only resume operation when the user has reset the unit. Qxd 4/30/09 11:03 AM Page 4 SAFETY BACK-UP FUSE In the unlikely case the heater does not respond to an overheat situation, the safety back-up fuse will engage. [. . . ] Additionally, normal wear and tear, including, but not limited to, minor discoloration and scratches are not covered by this guarantee. The rights under this guarantee shall only apply to the original purchaser and shall not extend to commercial or communal use. If your appliance includes a country-specific guarantee or warranty insert please refer to the terms and conditions of such guarantee or warranty in place of this guarantee or contact your local authorized dealer for more information. Waste electrical products should not be disposed of with Household waste. [. . . ]