User manual BIONAIRE BU3000

[. . . ] Do not let cord hang over edge of table or counter, or touch hot surface including the stove. Do not use appliance for other than intended use. Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling or cleaning. Do not operate at higher voltage than shown. [. . . ] Cleaning your humidifier every one or two weeks, depending on the water conditions is important in order to maintain efficient, healthy, odour-free operation. Water quality varies widely and, combined with build-up of mineral scale in your humidifier, may under certain conditions promote the growth of micro-organisms in the water tank. before cleaning , Please note the following: · DO NOT use soap, detergents, abrasives, gasoline, glass or furniture polish, or boiling water to clean any part of your Ultrasonic Humidifier. These will interfere with the proper operation of your unit and may affect its appearance. DO NOT use sharp or metal objects to clean mineral deposits in the reservoir. Contact with sharp objects can result in damage to the plastic. Mineral deposits should be soaked for up to 20 minutes in plain vinegar and water to help with their removal. DO NOT clean any part of your humidifier in the dishwasher. Before cleaning, set the humidity control switch to the Off position ( ) and unplug the unit from the electrical outlet. Carry the base and the tank to the sink, then drain and rinse the base and tank thoroughly to remove any sediment or dirt. Wipe clean and dry with a clean cloth or paper towel. If moisture forms on walls or window, turn the humidifier off. Be sure the humidifier is disconnected from the wall outlet and humidity control switch (C) is in the off position ( ). Place the base (D) where you want the unit to operate. Then, take the tank (E) off the unit to refill it (without moving the base). Remove the tank lid (G) and fill with cool, fresh tap water. If the humidifier is not level always turn the power off before handling it. NOTE: Do not fill the water directly into the base (D). Plug the power cord into a convenient electrical outlet. Power on light indicator (B) will illuminate when the unit is connected to main electrical power and operating. When the unit is out of water or when the unit is switched off, the Power on light indicator will not be working. Turn your humidifier on by rotating the humidity control switch (C) to the high position ( ) It will take a few minutes before full moist air output is obtained. [. . . ] Pack the humidifier in its original carton and store in a cool, dry place. And Ireland only: If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. And Ireland The wires in the mains lead are coloured as such: BROWN LIVE BLUE NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings 4 Please proceed as follows: The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. [. . . ]