User manual BIONAIRE BWM401

[. . . ] and Ireland WARNING - THIS APPLIANCE MUST BE EARTHED The wires in the mains lead are coloured as such: GREEN AND YELLOW - EARTH BROWN - LIVE BLUE - NEUTRAL Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows: The wire which is coloured GREEN AND YELLOW must be connected to the terminal which is marked with the letter 'E' or by the earth symbol or coloured GREEN or GREEN AND YELLOW. The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED. The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK. [. . . ] When plugged in, the Display will show the current room humidity. To start the unit, press the MODE/OFF Button for the HIGH (HI) manual setting. Press the Button again for the LOW (LO) manual setting. To stop the unit, keep pressing the Button until the Display reads OFF (OF). ACCUSETTM HUMIDISTAT MODE To take advantage of the AccuSetTM Digital Humidistat: 1. Press the MODE/OFF button until you reach AU (Automatic) Accuset. 2. Adjust the set humidity by using the Humidity Set Button. The Display will show a setting in the range 35% ­ 65% and the humidity can be increased/decreased in increments of 5%. When the room humidity level rises above the set humidity, the Humidifier will stop. When the humidity level drops below the set humidity, the Humidifier will turn on automatically. NOTE: The AccuSetTM Humidifier has memory. This means that when you turn the unit back on to AccuSetTM mode, it will remain at the setting the Humidifier was previously set at, unless the unit has been unplugged. REFILL PROCEDURE NOTE: When the Water Tank is empty and the water in the Heating Chamber is almost empty, the Red REFILL light will illuminate, the panel will display "FILL" and the Automatic Shut Off will activate. The unit will not operate again until you refill the Water Tank and reset the Humidifier as follows. Remove and refill the Water Tank, being sure to follow the Maintenance Instructions. The REFILL light should now be off (if not repeat steps 1 through to 2)). In about 5 minutes, the Humidifier will begin to produce moisture. If you do not plan to use the Humidifier for two or more days, make sure any residual water is drained from the Water Tank and Base to prevent algae or bacteria growth. AUTO SAFETY SHUT OFF This humidifier is equipped with a technologically advanced, safety system that requires the user to reset the humidifier if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the humidifier off. It can only resume operation when the user resets the unit. Press the reset button on the bottom of the unit. [. . . ] To avoid fire or shock hazard, plug the appliance directly into an electrical outlet and fully insert the plug. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, or near radiator, stoves, or heaters. Serious injury may result because of the high temperature of the water. [. . . ]