Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BIONAIRE CM1. We hope that this BIONAIRE CM1 user guide will be useful to you.
Lastmanuals help download the user guide BIONAIRE CM1.
Detailed instructions for use are in the User's Guide.
[. . . ] When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using the appliance. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs or near heat registers. [. . . ] The automatic shut-off tank cap valve allows the tank to be lifted out and removed without any water spillage. A suitable medication can be placed in the medication cup and warmed. The resulting vapor is then released into the moist air. cONTROL PANEL POWER Light - When illuminated , indicates that the heating element is powered. When extinguished, indicates that either the unit has been shut off or that the heating element is not activated due to an empty water tank. POWER On/Off Switch - This control is used to turn your WARM MOISTURE unit on or off. RESET Bar - This control, located on the bottom right side, resets the humidifier after it has shut down due to an empty water tank or after it has been cleaned. Once the tank has been refilled allow one minute for the cavity to fill then press the re-set bar. The reset bar should never be pressed when the unit is empty. A hard, level, water-resistant surface is necessary for proper operation. Remove the top cover (Figure 2) and then lift out the water tank (Figure 3). Turn the tank upright and remove the tank cap by twisting it completely off (Figure 4). Fill the tank with cool tap water as shown in Figure 5. Replace the tank cap, making sure the O-ring is in its correct position. Carry the full tank and carefully replace it, cap down, into the humidifier. Wait a few minutes for the cavity to refill. Allowing your humidifer to run out of water before filling the tank helps to self-clean the heating element. Press the reset bar if the power light does not illuminate. It may take up to 5 minutes before full mist output is obtained. When all the water in the tank has been used, the unit will shut down. Do not add any additives to the water in the tank or cavity. WARNING: All cleaning agents must be thoroughly rinsed away after use and before the unit is returned to service. [. . . ] Make sure all water is emptied from the tank and cavity. Leave the tank cap off allowing the tank to be exposed to air. Store the power cord in the power cord compartment. Bionaire® recommends storing the unit in its original box. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BIONAIRE CM1
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BIONAIRE CM1 will begin.
