User manual BIOSTAR GF7050V-M7 SE BIOS MANUAL

[. . . ] GF7050V-M7 SE BIOS Manual BIOS Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1 Main Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Advanced Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 3 PCIPnP Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 4 Boot Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 5 Chipset Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 6 Performance Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 7 Exit Menu. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 i GF7050V-M7 SE BIOS Manual BIOS Setup Introduction T he purpose of this manual is to describe the settings in the AMI BIOS Setup program on this motherboard. The Setup program allows users to modify the basic system configuration and save these settings to CMOS RAM. T he power of CMOS RAM is supplied by a battery so that it retains the Setup information when the power is turned off. Basic Input-Output System (BIOS) determines what a computer can do without accessing programs from a disk. [. . . ] Options: Disabled (Default) / Enabled Resume On PME# When you select Enabled, a PME signal from PCI card returns the system to Full ON state. For this function to work, you may need a LAN add-on card which supports the Wake on LAN function. Set the Wake on LAN (WOL) jumper on motherboard to enable i f applicable. Options: Disabled (Default) / Enabled Resume On PCIE Wake# When you select Enabled, a signal from PCI-E card returns the system to Full ON state. For this function to work, you may need a LAN add-on card which supports the Wake on LAN function. Set the Wake on LAN (WOL) jumper on motherboard to enable i f applicable. Options: Disabled (Default) / Enabled Resume On LAN(MAC) T his item allows you to enable or disable Wake On LAN from Soft-O ff fun ction. Options: Disabled (Default) / Enabled 15 GF7050V-M7 SE BIOS Manual Resume On Ring T his item allows you control the wake on ring function. Options: Disabled (Default) / Enabled Resume By RTC Alarm When " Enabled", you can set the date and time at which the RT C (real-time clock) alarm awak ens the system from Suspend mode. Options: Disabled (Default) / Enabled RTC Alarm Date (Days) You can choose which date the system will boot up. System Time You can choose the system boot up time, input hour, minute and second to specify. Note: If you have change the setting, you must let the system boot up until it goes to the operating system, before this function will work. 16 GF7050V-M7 SE BIOS Manual USB Configuration T his item shows the USB controller and using USB device information. BIOS SETU P U TILITY Advan ced USB Configurat ion Module Version - 2. 24. 2-13. 4 USB Devices En abled: Legacy USB Sup port USB 2. 0 Contro ller Mode BIOS EHCI Hand -Off [Ena bled] [HiS peed] [Ena bled] S elect Screen S elect Item C hange Option G eneral Help S ave and Exit E xit Enables support for legacy USB. AUTO option disables legacy support if no USB devices are connected. > USB Mass Sto rage Device Configu ration +F1 F10 ESC vxx . xx (C)Copyright 1985-200x, American Me gatrends, Inc. Legacy USB Support T his item determines if the BIOS should provide legacy support fo r USB devices like the keyboard, mouse, and USB drive. T his is a useful feature when using such USB devices with operating systems that do not natively support USB (e. g. Options: Enabled (Default) / Disabled USB 2. 0 Controller Mode T his item allows you to select the operation mode of the USB 2. 0 controller. Options: HiSpeed (Default) USB 2. 0-480Mbps FullSpeed USB 1. 1-12Mbps BIOS EHCI Hand-Off T his item allows you to enable support for op erating systems without an EHCI hand-o ff feature. Options: Enabled (Default) / Disabled 17 GF7050V-M7 SE BIOS Manual USB Mass Storage Dev ice Configuration BIOS SETUP UTILITY Advanced USB Mass Storage Device Configuration USB Mass Storage Reset Delay [20 Sec] Device # Emulation Type [Auto] Number of seconds POST waits for the USB mass storage device after start unit command. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit vxx. xx (C)Copyright 1985-200x, American Megatrends, Inc. USB Mass Storage Reset Delay T his item allows you to set the reset delay for USB mass storage device. Options: 20 Sec (Def ault) / 10 Sec / 30 Sec / 40 Sec Emulation Type T his item allows you to select the emulation type of the USB mass storage device. Options: Auto (Default) / Floppy / Forced FDD / Hard Disk / CDROM 18 GF7050V-M7 SE BIOS Manual 3 PCIPnP Menu T his section describes con figuring the PCI bus system. PCI, or Personal Computer Interconn ect, is a system which allows I/O devices to operate at speeds nearing the speed o f the CPU itself uses when communicating with its own special components. Notice Beware of that setting inappropriate values in items of this menu may cause system to malfunction. Main Advan ced PCIPnP BIOS SETU P U TILITY Boot Chipset Performance Exit Advanced PCI/P nP Settings WARNING: Setti ng wrong values in below sections may c ause system to malf unction. Clear NVRAM Plug & Play O/ S PCI Latency Ti mer Allocate IRQ t o PCI VGA Palette Snoopi ng PCI IDE BusMas ter OffBoard PCI/I SA IDE Card > PCI Resource > PCI Express Configuration [No] [No] [32] [Yes ] [Dis abled] [Ena bled] [Aut o] Clear NVRAM during System Boot. +F1 F10 ESC S elect Screen S elect Item C hange Option G eneral Help S ave and Exit E xit vxx . xx (C)Copyright 1985-200x, American Me gatrends, Inc. Clear NV RAM T his item allows you to clear the data in the NVRAM (CMOS) by selecting "Yes". Options: No (Default) / Yes Plug & P lay OS When set to YES, BIOS will only initialize the PnP cards used for the boot sequen ce (VGA, IDE, SCSI). [. . . ] Options: Enabled (Default) / Disabled USB 2. 0 Controller T his item allows you to control the USB 2. 0 controller. Options: Enabled (Default) / Disabled AZALIA AUDIO T his item allows you to control the onboard codec and on-chip codec. Options: Internal codec+E (Default) / Internal codec / External codec / Disabled 28 GF7050V-M7 SE BIOS Manual MAC ID Information T his item shows the onboard LAN MAC ID. Onboard LAN T his option allows you to control the onboard LAN. Options: Auto (Default) / Disabled Onboard LAN Boot ROM T his item allows you to enable or disable the Onboard LAN Boot ROM. [. . . ]