User manual BISSELL 1719

[. . . ] USeR'S GUIDe 1719 SeRIeS 220-240V 3 4 5 Safety Instructions Product View Product Features 6-8 Operations 8-9 Maintenance and Care 9-10 Troubleshooting 9-10 11 Consumer Services 12 11 Replacement Parts 12 Warranty Thanks for buying a BISSeLL Spot Lifter TM 2X Cordless Handheld Deep Cleaner We're glad you purchased a BISSELL Spot Lifter 2X cordless handheld deep cleaner. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your Spot Lifter 2X is well made, and we back it with a limited one-year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services department, so, should you ever have a problem, you'll receive fast, considerate assistance. [. . . ] To charge your Spot Lifter 2X, connect the round end of the charger cord into the power port on the back of the unit. Tip: After unit is charged (approximately 12 hours) unplug from outlet. This will aid in prolonging the life of the battery. 4. nOTe: Decreased operating time may indicate that the battery has built up a charging resistance. To recharge, first completely exhaust the battery, recharge it, then exhaust it once again before recharging a second time. This procedure may be required more than once. 1. Filling the solution/clean tank 1. 2. Remove solution/clean tank by grasping it firmly and pulling straight up. Add water and formula* to the indicated fill lines on the solution/ clean tank 2. Water Fill Line WATER FORMULA *note: your Spot Lifter 2X includes two trial size bottles of formula. Formula Fill Line 3. Replace cap and place solution/clean tank back on unit. 3. 6 6 www. bissell. com Operations (continued) Pre-treating 1. 2. Turn power switch "I" (ON). To pre-treat stained or highly soiled areas, hold Spot Lifter 2X above soiled surface and press spray trigger to spray cleaning solution. Let cleaning solution set for 3-5 minutes before cleaning. 2. Turn power switch "I" (ON). Hold Spot Lifter 2X above soiled surface and press trigger to spray cleaning solution, as in pre-treating step 2 above. Press front of Spot Lifter 2X firmly against surface and pull toward you to remove cleaning solution and soil. Repeat steps 2 and 3 until no more dirt or cleaning solution can be removed. For stubborn spots and soil, use brush to gently scrub soiled area while continuing to spray cleaning solution. To remove brush from unit, gently pull on brush tab and lift out. Tip: Immediate attention to a spill on upholstery can prevent permanent staining. 3. 5. nOTe: If Spot Lifter 2X stops spraying, turn power switch "O" (OFF) and check cleaning solution level. never run dry. Tip: Use the brush after applying cleaning solution and remove any surface soil. Using the brush before applying solution can push soil more deeply into carpet. Spot cleaning upholstery 1. Check manufacturer's tag before cleaning. "W" or "WS" on the tag means you can use your Spot Lifter 2X. If tag is coded with an "S" (with diagonal strike-through), or says "Dry Clean Only, " do not proceed. If manufacturer's tag is missing or not coded, check with your furniture dealer. 2. h bv g kvh gh bj j gh dd kll df kn hn hl jf Ads j j jh bb cv ghhj gc nOTe: If possible, check upholstery stuffing. [. . . ] Contact your local authorities for a safe disposal or recycling facility in your area. 3. 6. 7. Remove wire connectors from the battery pack. Keep battery packs together ­ DO NOT separate individual batteries. For proper battery disposal instructions, please contact your local authorities for requirements and regulations on safe disposal or recycling facilities in your area. [. . . ]