User manual BISSELL READYDRY

[. . . ] ReadyDryTM USER'S GUIDE 79T3 SERIES 220-240v 3 Safety Instructions 4 5 Product view Assembly 6 Special Features 7-10 Operation 10-11 Maintenance and Care 12 Troubleshooting 13 Consumer Services 14 Replacement Parts 14 Formulas 15 Additional Accessories 16 Warranty Thank you for buying a BISSELL ReadyDry We're glad you purchased a BISSELL ReadyDry carpet washer. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. By purchasing this product you are helping BISSELL with our commitment to reducing our impact on the environment through an expanding range of sustainable design efforts. Your carpet washer is well made, and we back it with a limited two-year warranty. [. . . ] Carry it to the sink or wherever you plan to dump the dirty water. Remove the tethered cap on the rear of the tank. Pour out the dirty water, rinse tank and replace the cap. To continue carpet washing refer back to page 7 and begin with "Fill the clean water/formula tank. " WARNING:fire To reduce the risk of 2. 3. 5. and electric shock due to internal component damage, use only BISSELL cleaning fluids intended for use with the carpet washer. Non-BISSELL cleaning solutions may harm the machine and void the warranty. If carpet washing is complete, refer to the "Maintenance and care" section on page 11. Pretreating (optional) 1. Pretreating (optional) Pretreating is recommended to improve cleaning effectiveness for heavily soiled carpet in high traffic areas such as entry ways and hallways. Please keep in mind that pretreating will wet the carpet and could impact dry time. Using the BISSELL Tough Stain Pre-cleaner, generously spray evenly over soiled area, do not overwet. Clean as normal using your BISSELL ReadyDry, following the instructions on page 7. ReadyToolsTM (cleaning with attachments) Your ReadyDry carpet washer comes equipped with a hose and at least two attachments for cleaning stairs, upholstery, stains and more. Important!If using the machine to clean upholstery, check upholstery tags. 1. Check manufacturer's tag before cleaning. "W" or "WS" on the tag means you can use your ReadyDry. If the tag is coded with "X" or "S" (with a diagonal strike through), or says "Dry Clean Only, " do not proceed. Rubber Stopper Maintenance and care Machine care For best results, a few simple steps can assure your carpet washer is well maintained after your cleaning is complete. Unplug the machine and wrap the power cord. After emptying the dirty water tank, rinse it with running hand hot tap water, taking care to clean all around the interior. If necessary, check and clean out the lint screen after each use by wiping clean any visible residue. Replace the dirty water tank back into the machine. Any loose hair or debris can be pulled from the PowerRoller and thrown away. To clean the attachments, remove from hose and rinse in clean, running water. Clean the hose by suctioning clean water from the tap. Before wrapping back on machine, lift end of hose and stretch out to ensure all water is cleared from hose. [. . . ] Turn ReadyTools dial to FLOOR CLEANING 3. Turn power switch off and empty tank if necessary. If tank is not full, wait 30 seconds and turn power switch on 4. Turn power switch off and empty tank Remedies 4. Dirty water tank may be full Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store 12 www. bissell. com BISSELL Consumer Services If your BISSELL product should require service: In the UK, Australia or New Zealand, call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. [. . . ]