User manual BLAUPUNKT ACD 9430

[. . . ] Operating Instructions ACD 9430 QuickOut a 1 2 3 4 5 6 7 8 9 1 2 Radio h g f e ab c d 10 b QuickOut 3 CD 9 i j 9 3 Front Panel Description 1 ON/OFF Switch on the set by turning knob 1. 2 AUD button (sound control/broader interior sound impression) BAS ­ Adjustment of the low frequencies via buttons </> 7. TRE ­ Adjustment of the high frequencies via buttons </> 7. BAL ­ Adjustment of the left/right volume via buttons </> 7. [. . . ] Then it may only be used again after the appropriate code number has been entered (see car radio passport). If the power supply to the radio is interrupted while the code system is switched on, you need to know the right code number. The radio will operate again as soon as you have entered the right code number. If you lose your radio passport and have forgotten your code number, you will not be able to restart the set after the power supply has been interrupted. In this case, your radio can only be reset in our central customer service workshop or in one of our service agencies abroad. Installation/connection The code system can only be switched on and off, if the radio is connected to permanent power. If you like to install your new car radio by yourself or add other audio components to the existing ones, then please read carefully the enclosed instructions on installation and connection. Do not connect the loudspeaker outputs to ground!Only use the accessory and replacement parts approved by Blaupunkt. Wrong code number entered It should not be possible for thieves to ascertain the code number by trial-and-error. This is why the set will be blocked for a certain period of time, if an incorrect code number is entered. In this case, "- - -" will appear in the display. This waiting time is 10 seconds after the first three attempts, and 1 hour following subsequent attempts. After 19 unsuccessful attempts, "OFF" will appear in the display and the set can no longer be restarted. Note: Keep you car radio passport with the code number in a safe place in order to avoid "unauthorized access" to your car radio. Switching the code system on Precondition: The radio must be connected to permanent power. In order to switch the code system on: · Turn the radio off. · · Hold down the preset buttons 1 and 4 simultaneously. "Cod" briefly appears before the radio begins to operate. · Release preset buttons 1 and 4. "Cod" will be briefly displayed each time the radio is turned on. 14 Restart following interruption of power supply (Code system switched on) · · · Switch on the set. "Cod" will appear in the display. Briefly press preset button 1, "000" will appear in the display. Enter the code number given in the Blaupunkt car radio passport: Preset button 1 only allows to choose "0" or "1". The first "0" will not be displayed. - Press preset button 1 until "000" appears in the display. [. . . ] The ARI indication lights up on display 9 c. Inserting the Disk With this set you can play the normal standard CDs without having to use an adapter: · Switch the set on. · Insert the CD (label side up) without applying force. The disk is automatically pulled into the unit to reach the playing position. Once it has been fed in, reproduction starts. Then tune in to one of the traffic stations of your area. [. . . ]