User manual BLAUPUNKT ACR 3231

[. . . ] 11 Stereo - mono switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Storing stations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Storing the strongest stations automatically . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Recalling stored stations . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Then press the station button quickly and repeatedly if necessary. = TREB (treble) For adjusting the treble > BASS For adjusting the bass 3 Cassette tape slot 4 FR (Fast Rewind): Rewinds tape quickly to the beginning. 5 PROG (Autoreverse) To switch over to the other tape track press both buttons. 6 FF (Fast Forward) Forwards tape quickly to the end. 8 Station selection automatic or manual ("m" in display). Switch over by pressing lo · m 9 9 lo · m Changing the search tuning sensitivity for FM stations Io lit up in the display indicates normal sensitivity for the station search function. Io not lit up in the display indicates high sensitivity for the station search function. m lit up indicates manual station fine tuning. 10 Manual station search m (manual) must be lit up in the display. If it is not, switch it on by pressing lo · m. · The frequency will move up or down in short intervals. If you hold the button pressed, then the frequencies will move up or down more quickly. Stereo - mono switch If you would like to switch between stereo and mono reception: · Press lo · m for approximately 2 seconds. If you are playing a cassette, it will be interrupted until the traffic message has ended and will then resume operation. Switching the traffic messages (ARI) on and off If you want to switch the reception of traffic messages (ARI) on or off · Press ARI. ARI will light up in the display, when the reception is switched on. Now the radio will only pick up those stations broadcasting the ARI signal. Warning beep Should you leave the reception area of the station you are tuned to, then you will hear a warning beep after approximately 30 seconds. If you should press a button preset for a station which does not broadcast the ARI signal, then you will also hear a warning beep. store up to five stations using the button 1-5. · Select the memory bank by pressing FM·T. · · Select the button 1-5 to store the new station and press it. to tune in the station you Press want to store (automatically or manually). · Press the button 1-5 and hold it. First the station will be muted and then become audible again. The station has been stored in the memory bank. [. . . ] · Press FR and FF at the same time. At the end of the tape, the unit will automatically switch to the other track. Note: If there is too much tension on the cassette tape during playback, it may switch to the other track by itself. Sometimes it helps to rewind the cassette tape completely. 13 PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS ENGLISH DEUTSCH Cassette tape operation Appendix Care of your audio equipment We recommend that you use only C60/C90 cassette tapes in your car radio. [. . . ]