User manual BLAUPUNKT BERLIN RCM 303A

[. . . ] Lay the CORA bus wire from the operating panel (ACR) to where the tuner, CDC interface and the amplifier have been installed. Lay the ACR's optical wave guide and the wire of the measuring microphone to the amplifier. Initial start-up After the installation has been completed, re-connect the negative pole of the battery. The display should show a frequency and the word Suchlauf Scan and the unit is now operating in the tuner mode. After a time (depending on the number of stations which can be received, approximately 2 minutes), the station names (RDS stations) and their frequencies will be visible in the display. [. . . ] Push the retaining spring into the notch in the base, insert the cover where the base was located, lay the wire through the base and reassemble the display (Fig. In order to mount the base, unscrew it and use four screws to fix it to the installation location (Fig 7). Fig. 3 9 Operating panel (ACR) The mounting frame included with this unit makes an installation possible in vehicles with a standard DIN radio opening measuring 182 x 53 mm, 165 mm installation space and a dashboard thickness measuring from 1 to 20 mm at the fastening tabs. Blaupunkt is able to supply installation sets for the most common vehicles with non-standard measurements for units measuring 50/52 mm. Check to see whether the vehicle is standard or non-standard and use a vehicle-specific installation set if necessary. When using an installation set for 52 mm units, you must affix 4 spacer plates with the order number 8 601 055 056 on the upper and lower sides of the unit. The car radio is installed in the space provided by the vehicle manufacturer. Open this space (remove the shelf or cover plate) or cut out a space measuring 182 x 53 mm. Reach into this opening in order to find out which fixing tabs can be bent over. Hint: Try to bend over all of the fixing tabs (Fig. Insert the mounting frame into the opening and bend over the fixing tabs with a screwdriver. Lay the power supply wire, the display wire, the optical wave guide and CORA bus wire (round plug) to the installation location and hook them up to the ACR (Fig. Operating panel ­ Installation Connect all of the corresponding wires. Screw the display wire tight and push the operating panel into the mounting frame from the front until the side springs lock into place (you will hear a definite clicking sound). Operating panel ­ Removal Insert the release bracket into the holes on the left and the right of the cover panel until it locks into place. 1 Display CORA bus checkpoint 2 Optical wave guide to amplifier checkpoint 3 Plus (pin 15) connected to ignition Switch plus output. Illumination hook-up Earth to the chassis checkpoint 1 Continuous plus (pin 30) to the battery checkpoint 1 Fig. 3 10 Tuner The tuner can be installed either vertically or horizontally with the installation material provided (Fig. Lay the antenna, power supply and CORA bus wires to the point of installation. Affix the CORA bus wire to the plug (Fig. Plug in the plugs for the antenna, the power supply and the optical wave guide (Fig. Plug in the CORA bus plug and screw it tight (Fig. [. . . ] 2 DNC adjustment In order to perform the DNC adjustment, activate the DSC menu by pressing the MOD button (approx. Set the cursor to DNC ADJUSTMENT and confirm by pressing the ENTER key. Set the cursor to YES and start the adjustment process by pressing ENTER. During the adjustment process, the vehicle must be closed and all persons outside. [. . . ]