User manual BLAUPUNKT BREMEN MP76

[. . . ] Radio CD SD/MMC MP3 Bremen MP76 7 646 828 310 Operating instructions http://www. blaupunkt. com 2 1 3 4 5 6 7 13 12 11 10 9 8 14 2 Controls 1 Button to switch the device on and off Muting the device 2 Volume control 3 button to unlock the detachable control panel : AUDIO button for setting bass, treble, balance, fader and X-BASS (short press) Calling up DSA Max equalizer (long press) < SOURCE button to start the CD or CD changer playback or Compact Drive MP3 (only if connected) or to start the radio mode or Playback of an external audio source (only if connected) = TUNER button for direct selection of radio mode Calling up the radio function menu (only possible in radio mode) > Slot for MMC/SD ENGLISH 4 NEXT button to display additional pages of a menu Changing the memory bank in radio mode 5 Softkeys, the function of the softkeys is dependent upon the respective content of the display 6 DIS·ESC button to change the display and exit menus 7 button to open the foldable and detachable control panel ; Display 8 Joystick and OK button 9 MENU button to call up the menu for the basic settings (short press) Switching demo mode on/off (long press) 55 Contents Notes and accessories. . . . . . . . . . . . . . . . . . . . . . 58 Disposal of old unit (EU countries only) . . . . . . . . . . . . . . . . . . . . . . . . 58 Road safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 Safety note . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The display shows the adjusted time, the hours are flashing. u Move the joystick 8 up or down and adjust the hour. u Move the joystick 8 right and change the entry position. u Move the joystick 8 up or down and adjust the minutes. Selecting timers After you have set the timers, you can select between the two timers. The timer which you adjusted last is always active. To select a timer, u in radio mode, hold the TUNER button = pressed for longer than two seconds. u Press the softkey 5 with the display label "TIMER1" to select the first timer or "TIMER2" to select the second timer. u press the TUNER button = or the OK joystick 8. The settings are saved. 78 Traffic information Traffic information Your device is equipped with an RDS-EON receiver. EON (Enhanced Other Network) is the transmission of station information within a broadcasting network. Whenever a traffic announcement (TA) is broadcast, the system switches automatically from a station that does not provide traffic reports to the appropriate traffic information station within the broadcasting network that does. Once the traffic report has been played, the system will switch back to the programme that you were listening to before. Switching traffic information priority on/off u Press the TUNER button = in radio mode. The display shows the radio function menu. u Press the softkey 5 with the display label "TRAFFIC" repeatedly until the desired setting "TRAFFIC INFO ON" or "TRAFFIC INFO OFF" appears. Note: The TA menu is displayed during a traffic announcement. To interrupt the current traffic announcement, u press the softkey 5 with the display label "TA EXIT". If you want to switch off the priority for traffic announcements in general, u press the softkey 5 with the display label "TA OFF". Notes: You will hear a warning beep: · If you leave the reception area of a traffic information station that you are currently listening to. · If you leave the reception area of a traffic information station that the system is tuned into while listening to a CD, and the subsequent automatic seek tuning cannot find a new traffic information station. · If you retune the radio from a traffic information station to a station that does not broadcast traffic information. If you hear the warning beep, you can either switch off traffic information priority or tune into a station that broadcasts traffic information. Setting the volume for traffic announcements u Press the MENU button 9. u Press the softkey 5 with the display label "VOLUME". u Press the softkey 5 with the display label "TRAFFIC". [. . . ] The display shows the standard text for the switch-on message. The input mark is at the beginning of the line and flashing. To input a different text, u press the joystick 8 left or right to move the input mark. u Set the desired letter by pushing the joystick 8 up or down. [. . . ]