User manual BLAUPUNKT CAMBRIDGE CD125

[. . . ] the unit is protected by a quick-acting fuse of 5 A. Note: By means of the support included in delivery you can mount the set in cars with a DIN car radio cutout of 182 x 53 mm, an installation depth of 165 mm and an instrument panel thickness around the fixing clips of 1 - 20 mm, see fig. [. . . ] For cars with other cutout dimensions Blaupunkt delivers car-specific installation kits for common car types for 50/52 mm sets. Use enclosed distance plates only for installation kits of 52 mm sets. Please check the dimensions and, if necessary, use a car-specific installation kit, e. Lubricate it with graphite grease (important for good ground contact). If the plus cable is connected to pin 15 of the fuse holder (plus connected via ignition lock) downstream of the fuse, the in-car radio can be switched on and off with the ignition key. Hook up the positive cable with the connector device to terminal 30 of the fuse holder (permanent + 12 V) behind the fuse. Connection with QuickOut installed ex factory If your car is fitted with a QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed, see fig. Insert the car radio from the front into the support and push in until the stop springs on the sides engage right and left (distinct click to be heard). Insert the brackets right and left into the provided trimplate holes and push in until you hear a distinct click (lateral springs are unlocked). Note: Locked brackets can only be removed after taking out the unit. Ground cable Do not connect the ground cable to the negative pole of the battery. Route the ground cable to a suitable ground point (car body screw, car body metal sheet) and shorten it accordingly. [. . . ] Route the ground cable to a suitable ground point (car body screw, car body metal sheet) and shorten it accordingly. Remove the insulation from the ground cable and attach the forked cable lug (if necessary, solder it). [. . . ]