User manual BLAUPUNKT CAROLINA AG F. DJ

[. . . ] @ button - opens the flip/release panel Arrow-key block OK button - confirms menu entries and starts the scan function X-BASS button to adjust and switch X-BASS on/off AUDIO button (Audio) - adjusts bass and treble, balance and fader Key block 1 - 6 TRAF button, switches traffic information standby on/off SRC button - selects between Cassette, CD changer (if connected) and AUX sources 5 6 7 8 26 TABLE OF CONTENTS Road safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 International telephone information . . . . [. . . ] Switching on/off using the button 3 To switch the unit on, press the button 3. To switch the unit off, hold the button 3 down for more than two seconds. The car radio is now switched off. 30 VOLUME ADJUSTMENT The system volume can be adjusted in steps from 0 (off) to 66 (maximum). This feature enables you to lower the system volume instantaneously (mute). DEUTSCH PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Volume adjustment Mute setting To raise the system volume, turn the volume control 2 to the right. Briefly press button 3. "MUTE" appears on the display. Activating the mute setting The unit's mute level is adjustable. To lower the system volume, turn the volume control 2 to the left. Setting the switch-on volume You can set the volume at which you wish the car radio to play when switched on. Press the MENU button 8. Press the or button : repeatedly until "MUTE LEVEL" appears on the display. Press the MENU button 8. Press the or button : repeatedly until "ON VOLUME" appears on the display. If you select the "LAST VOL" setting, the volume played before the unit was last switched off will be reactivated. Note: To protect your hearing, the poweron volume is limited to a value of "38". If the volume level was higher when the unit was switched off and the "LAST VOL" setting is selected, the volume will be reset to "38" when the unit is switched on again. When you have finished making your changes, ; twice. Use the mute level. buttons : to set the When you have completed the setting, press either the MENU button 8 or OK ; twice. Use the Telephone Audio/Navigation Audio If your car radio is connected to a mobile telephone or navigation system, then when the telephone is taken "off the hook", or when the navigation system is speaking, the car radio is muted. The telephone conversation or speech output are reproduced via the car radio speakers. You will then only be able to switch to stations that you have received once already. To do so, use the Scan or Travelstore function. Hold down one of the preset station buttons 1 - 6 > on which you wish to store the station for more than two seconds. 34 RADIO MODE DEUTSCH Storing stations automatically (Travelstore) You can store the six stations with the strongest reception in the region automatically (only FM). The stations are stored in the FMT memory. Note: Stations that were previously stored in this memory are deleted in the process. Ending SCAN, continuing to listen to a station Press the OK button ;. The scanning process is completed, the station last scanned remains active. Hold down the BND / TS button 5 for more than two seconds. The automatic station-storing procedure begins. "TRAVEL-STORE" appears on the display. Once the process is completed, the station stored in FMT memory location 1 is played. edly until "SCANTIME" appears on the display. Use the Once the setting has been completed, press the MENU button 8 or OK ; twice. Note: The set scanning time also applies to scanning in the CD and CD changer mode. Listening to preset stations Select the memory or frequency range. ton 1 - 6 > of the desired station. Scanning receivable stations (SCAN) You can briefly listen in to all receivable stations. The scanning time can be set in the menu at between 5 and 30 seconds. Starting SCAN Hold down the OK button ; for more than two seconds. "SCAN" appears briefly on the display, followed by the current station name or frequency, which flashes. Besides transmitting the station name, some FM stations also provide information on the type of programme they are broadcasting. [. . . ] Ending Pause Press the button 1 pause. Play then resumes. > during the 43 CLOCK - TIME CLOCK - Time Briefly displaying the time Press the / DIS 7 button briefly to display the time. Press the buttons : to switch between the 12 and 24-hour mode. Press the MENU button 8 or OK ; once you have completed the setting. Setting the time Setting the time manually To set the time manually, press the MENU button 8. Viewing the time with the car radio switched off and the ignition on To view the time when the car radio is switched off and the ignition is switched on, press the MENU button 8. "MENU" appears on the display. Press the or button : repeatedly until "CLOCKSET" appears on the display. button :. Press the The time appears on the display. [. . . ]