User manual BLAUPUNKT CDC-FM08

[. . . ] 12 Switching on/off with the ignition: . . . . . 12 Starting CD playback . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Stopping CD playback . . . . . . . . . . . . . . . . . . . . . . . . . 13 Selecting a CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Never use your car audio system in a way that could distract you. Please keep in mind that you travel a distance of 14 m per second at a speed of only 50 km/h. Should the traffic situation become particularly demanding, we advise you not to use the CDC-FM 08 remote control and the car radio. Starting CD playback Switch on the CDC-FM 08 by pressing or via the ignition of your vehicle. The CD programme will continue on from where it left off. Use your car stereo to select the station or frequency on which the modulator (tuner interface) signal is received. When using the equipment for the first time, proceed with chapter "First operation". Inserting CDs Insert one or several CDs into the magazine (printed surface facing up). Slide the magazine into the CD changer in the direction of the arrow. Please observe the operating instructions of the CD changer equipment. Close the door of the changer. Installation If you would like to install the remote control Ejecting CDs yourself or add other audio components to Open the door of the CD changer and press existing ones, then please read the enclothe eject button. sed instructions on installation and connection carefully. 12 Stopping CD playback Press during CD playback to interrupt the CD programme. Press again to continue playback on from where it left off. Selecting a track CD-Scan Selecting a CD When CD playback starts, the current CD and track numbers will light up in the display. 13 PORTUGUÊS ESPAÑOL Press the rocker switch repeatedly to skip over several tracks. If you have reached the last CD, the number displayed will start again with the first disc detected in the magazine. SVENSKA <</>> CD selection >> CD up << CD down Use this function to scan the tracks of all discs inserted in the changer for 10 seconds each. To start the Scan function: · Press SCAN briefly. SCN will appear in the upper right section of the display. All tracks on the current CD will / Track selection be scanned one after the other in ascending Track up, fast forward (audible). When reaching the end of a disc the Track down, fast reverse (audible). system will automatically switch to the first To re-start the current track. Press the button repeatedly to skip several To stop the Scan function and continue listening to the scanned track: tracks. The number of the selected track will be dis- · Press SCAN briefly. When you reach the end of the disc, the sys- Random play tem will automatically change to the next or You can have the CDs or CD tracks played previous CD in the magazine. The following options are available: all tracks of a disc (RDM) or all discs (RDM CDC). To start RDM: · Press RDM briefly. [. . . ] Insert discs and magazine correctly. · CD is played back but no music audible. · · · · · · · · · · Take care that all components are properly connected. Remove the magazine, leave changer door open for approx. Install changer at correct angle. · · No display on the remote control. Playback permanently "jumping" while the vehicle is moving. · · · · Modulator fuse blown. [. . . ]