User manual BLAUPUNKT FREIBURG RCM45

[. . . ] When drilling holes, be sure not to damage any vehicle parts (battery, cable, fuse box, etc. The positive cable must have a cross-section of at least 1 mm. [. . . ] Remove the insulation from the ground cable and attach the forked cable lug (if necessary, solder it). Scratch off the paint from the contact area of the ground point and lubricate it with graphite grease (important for good ground contact). Install the car radio into the DIN cutout provided in your car's dashboard ex factory. Prepare the car radio DIN cutout (unlock shelf or dummy cover) or cut out the car radio compartment to 182 x 53 mm. Grasp behind the car radio cutout and check how many of the fixing strips of the car radio support may be bent. note: Try to bend as many fixing strips as possible. Insert the support into the cutout and bend the appropriate fixing strips with a screwdriver, see fig. If the plus cable is connected to pin 15 of the fuse holder (plus connected via ignition lock) downstream of the fuse, the in-car radio can be switched on and off with the ignition key. In addition, the set automatically switches off after one our in order to avoid that the battery goes flat. The hour logic will not be activated whrn connecting the permanent +12 V line (terminal 30). [. . . ] Om denna kontakt ansluts till bilstereon kortsluts styrspänningen till antenn/förstärkare mot jord och en ledningsbana i radion brinner av. Telephone Mute Quando o telephone chama ou entra em funcionamento, o som do aparelho é cortado automaticamente. [. . . ]