User manual BLAUPUNKT GTA 2 SPECIAL MK II

[. . . ] - When you drill holes, ensure that you do not damage any vehicle components. We provide a manufacturer guarantee for our products bought within the European Union. 200 D-31139 Hildesheim, Germany Guarantee for the USA Please read these operating instructions before using the equipment for the first time. We provide a manufacturer guarantee for our products bought within the United States of Amerika. [. . . ] Do not connect loudspeakers to earth, use only the referenced terminals. The performance of an amplifier can only be as good as its installation. A correct installation increases the overall performance of your car sound system. the GTA amplifier should be installed by a trained person. If you would to install it yourself, please read these installation instructions very carefully and allow yourself sufficient time for the installation. The amplifier is suitable for connecting a car sound system with cinch connections. For the connection to car sound systems with ISO connection, use Blaupunkt ISO cinch adapters (7 607 893 093 or 7 607 855 094). Quadro mode Max power Stereo mode Max power Quadro mode Max power Quadro mode RMS power Stereo mode RMS power Quadro mode RMS power Frequency response Signal-to-noise ratio Distortion factor (RMS) Stability Input sensitivity Low-pass filter (Low Pass) High-pass filter (High Pass) Bass boost Dimensions W x H x D (mm) 190 x 56. 4, 5 Connection examples Connection of the voltage supply Connection to car sound system with cinch output Loudspeaker connections This allows the amplifier to be switched on and off using the on/off-switch of the radio device. The Level control is used to adjust the input sensitivity of the power amplifier to the output voltage of your car sound system preamplifier output. If a car sound system of a third party manufacturer is connected, the input sensitivity must be adjusted corresponding to the manufacturer data. A few important explanations in this context: By turning the control clockwise, the input sensitivity of the amplifier and, therefore, also the volume increases. However, this is not a volume control; no further amplifier output can be achieved in the end position, even if it may sound like that at the beginning. The system merely increases the volume faster if the volume control of the car sound system is turned up. (If the amplifier is to be jumpered, continue with the section "Bridged loudspeaker connections" at this point). As with every audio component, the correct polarisation of amplifier and loudspeakers is of essentially importance for a good bass response. For this reason, ensure that the positive (+) connection of the amplifier is connected with the positive connection (+) of the loudspeaker; the same applies to the negative (-) connections. In addition, the left amplifier channel must be connected with the left loudspeaker and the right amplifier channel with the right loudspeaker. [. . . ] Red LED: Output stage is electronically switched off due to an error. Please use the return and collection systems available to dispose of the product. Subject to changes Låt oss bara till sist säga några ord om hälsoskydd: Tänk på om du lyssnar på musik i bilen att en långvarig ljudnivå över 100 dB kan leda till bestående hörselskador och till och med dövhet. Därför är det viktigt att vid anslutning se till att den positiva anslutningen (+) på förstärkaren är kopplad till högtalarens positiva anslutning (+). [. . . ]