User manual BLAUPUNKT HEILBRONN RCC 24

[. . . ] When drilling holes, be sure not to damage any vehicle parts (battery, cable, fuse box, etc. The positive cable must have a cross-section of at least 1 mm. [. . . ] When connecting a fully automatic motor antenna, use the cable clamp to fasten the control cable of the motor antenna to the control cable. Insert the car radio from the front into the support and push in until the stop springs on the sides engage right and left (distinct click to be heard). Insert the brackets right and left into the provided trimplate holes and push in until you hear a distinct click (lateral springs are unlocked). Note Locked brackets can only be removed after taking out the unit. Install the car radio into the DIN cutout provided in your car's dashboard ex factory. Prepare the car radio DIN cutout (unlock shelf or dummy cover) or cut out the car radio compartment to 182 x 53 mm. Grasp behind the car radio cutout and check how many of the fixing strips of the car radio support may be bent. note: Try to bend as many fixing strips as possible. Insert the support into the cutout and bend the appropriate fixing strips with a screwdriver, see fig. 6 Connection with multiple plug installed ex factory For vehicles with a system plug installed ex factory Blaupunkt offers an adapter cable for the common vehicle types. Connection with QuickOut installed ex factory If a car is fitted with QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed. Ground cable Do not connect the ground cable to the negative pole of the battery. [. . . ] Sätt in bilradion framifrån i fästanordningen och skjut in, tills hållfjädrarna på sidorna till höger och till vänster griper in (ett tydligt knäpp hörs). Stick in byglar till vänster och till höger i de befintliga hålen i panelen och tryck in så långt, att ett tydligt knäpp hörs (sidofjädrarna går ur ingrepp). [. . . ]