User manual BLAUPUNKT HELSINKI RTM 127

[. . . ] This connector must not be used for connecting the car radio!You must not connect your Helsinki car radio to an existing 8-pin +/- ISO connector in your car. Our warranty shall be vain if the connection is made inadequately. [. . . ] 5 mm2), install the enclosed ISO +/- cable (one brown, orange, yellow/green wire and two red wires) together with the universal power supply cable (available at your specialist dealer; P/N 7 607 884 093); see Fig. For this type of connection, first check whether you have passive or active loudspeakers installed in your car. active loudspeakers have an integrated amplifier , passive loudspeakers do not have an amplifier. For more information contact your car dealer or audio dealer. If your car is equipped with passive loudspeakers (4 ohms) you can adapt the ISO connector installed in your car. Use ISO cable (7 607 647 093) to prolong your wiring. If active loudspeakers are installed in your car, you can order the necessary adapter cable for various vehicles from your specialist dealer. Combination antennas, for example, are an interesting solution. For more information please contact your Bosch dealer. In new vehicles with antenna prefitting, e. VW, Seat, Audi, the power is supplied to the antenna via the antenna cable (see user manual of your car). If you wish to replace the original equipment for a conventional car radio, you need to purchase an antenna duplexer (P/N 7 691 290 202) from your specialist dealer. Information on how to install and connect your antenna is provided in the antenna installation instructions. According to the antenna type you wish to install, it may be necessary to use the antenna adapter with holder included in the delivery (see Fig. 8 LF = left front, RF = right front LR = left rear, RR = right rear Handsfree microphone connection (page 6) . Fix the guide pin with or without spacer on the stud at the car radio rear side. After you have installed the antenna, tighten the connection at your car radio by hand und add another 1/4 rotation using pliers. Note: Make sure the telephone wires are not routed close to the loudspeaker wiring. [. . . ] Positive connection (switched via ignition) If you connect the positive cable of the fuse holder (terminal 15) behind the fuse, you can turn the car radio on and off with the ignition. Also, your car radio will turn off automatically after one hour to protect the battery. The 1-hour logic will not be activated, if the constant power wire (terminal 30) is connected. [. . . ]