User manual BLAUPUNKT RC-05

[. . . ] Safety notes Installation and connection guide Disconnect the negative terminal of the car battery during installation and connection. When drilling a hole, make sure not to damage any vehicle parts (battery, cable, fuse box, etc. [. . . ] ) Make sure that the holding strap has engaged into the fixing plate!Then cut the strap using a knife or any similar device, fig. (The ends of the holding strap must not overlap. ) If necessary, attach the compensation rubber elements to the inner side of the control unit, depending on the steering wheel diameter. Use both rubber parts where required, see fig. Try out first before finally gluing the parts in place. Then attach the control unit on the right as shown in fig. 2 (see arrow 1), engage it, and turn it to the left (push back, see arrow 2). Finally press down firmly and lock using the attached tool or a small screwdriver or pen, see fig. Avoid turning the control unit after it has been finally attached. [. . . ] connect the IR remote control cable across the car radio and the existing wire harness. Connect the cable between the upper and lower chamber (2. [. . . ]