User manual BLAUPUNKT KANSAS AG F. DJ

[. . . ] 54 Traffic safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Telephone mute . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To start the Scan function: · Press SCA briefly. All of the stations on the waveband selected and within reception range will be scanned one after the other. "SCAN" and the station name or frequency will flash alternately in the display. Changing the scan time The scan time can be set from between five to a maximum of 30 seconds. Please refer to the section on "DSC programming - SCANTIME". Selecting the seek tuning sensiIf necessary, switch off PTY on menu level tivity You can alter the automatic seek tuning sensitivity. If "lo" is displayed, the radio will only pick up strong, local stations (low sensitivity). If "lo" does not light up, the radio will also pick up weaker, more distant stations (high sensitivity). If you want to alter the sensitivity level, please refer to the section on "DSC programming - LO/DX"). 62 Switching from stereo to mono (FM) If reception is poor, you may get better sound quality by switching from stereo to mono in the DSC menu. Each time the radio is switched on, stereo playback is activated automatically. The unit will automatically switch to mono if the signal received is not strong enough for stereo playback. If you would like to switch to mono, refer to "DSC programming - STEREO/MONO". The mode selected is indicated briefly in the display. PTY - Program Type PTY is an RDS service which an increasing number of broadcasting stations have begun to offer. You can assign different program types to each preset position. Please refer to the next section on "Storing program types". b) Using the << >> buttons on the rocker switch When PTY is switched on, you can select a program type using buttons << >>. · Press << or >>; the program type selected last will be displayed for 3 seconds. 64 · During this period press >> (forwards) or << (backwards) to select the desired type. · Press << or >> as many times as required. If you would like to listen to a station with the selected PTY, · press / to start the seek tuning function. If the radio is unable to find a station offering the selected program type, the display will show "NO PTY" and a beep tone will be emitted. The radio will select the station which was tuned into before seek tuning was activated. Storing program types Each of the preset buttons ST1 - ST6 has been assigned one program type at the factory. If desired, you can also replace these with other available program types. [. . . ] Dolby B NR The noise reduction system manufactured under licence by the Dolby Laboratories Licensing Corporation. The word DOLBY and the double-D symbol ( ) are trademarks of the DOLBY Laboratories. Cassettes which have been recorded with Dolby B NR* exhibit significantly less tape noise as well as much greater sound dynamics. DSC ­ Direct Software Control With the help of DSC it is possible to adjust the basic factory settings to your own personal preferences. [. . . ]